652237

Siemens DE18307M Manual

7
Zoom out
Zoom in
Previous page
1/28
Next page
7
en
Operating the appliance
Switching the appliance on and off
The continuous-flow heater switches on and heats the water
when the warm water tap is opened. It switches off again if
the water tap is closed.
The factory default setting for the warm water outflow tem-
perature is 55 °C.
Note: The electronic control unit senses the input water’s
temperature and rate of flow and automatically adjusts the
power consumption in order to obtain the set output water
temperature (up to the power limit).
Increasing the water temperature
If the supply water temperature is low and the flow-rate is
high, then it may happen that the set output water tempera-
ture is not obtained because the power limit is exceeded.
This is signalled by rapid flashing of the status display.
■ If this happens, then slightly close the warm water tap.
Status display
LED Appliance status
Off Off
Lights green On
Flashes green (1/s) The set temperature is not obtained;
the rate of water flow is too high for
appliance rating (the appliance has
reached the power limit). See “A fault,
what to do?”
Flashes green (2/s) Cold-water rinse-through phase
Flashes red See “A fault, what to do?”
Startup after power failure
■ Open the warm water tap fully and allow water to flow
until it is warm.
Using the appliance after switching off
the water supply
■ Switch off the appliance (unscrew the fuse in the
fusebox).
■ Open the warm water tap and keep it open until the air
has been completely forced out of the water pipe.
■ Switch the fuse back on again.
■ Open the warm water tap fully and allow water to flow for
at least one minute,
Only then (for safety reasons) will the appliance begin to
heat. The appliance is now ready to operate.
Winter operation
Note: It is possible in winter that the supply temperature of
the water is reduced and the required outlet temperature is
no longer achieved.
■ Reduce the water flow at the tap until the desired water
temperature is reached.
Cleaning
■ Only wipe off the appliance using a moist cloth.
■ Do not use acidic or abrasive cleaning materials.
■ Do not use a steam cleaner.
Customer Service
We ask you to always provide the E-No. and the FD-No. of
your appliance when calling in a customer service engineer.
You will find the numbers on the ratings plate on the inner
side of the front flap.
The contact information for your country can be found on
the last pages of these instructions.
Environmentally-friendly disposal
■ Dispose of the packaging in an environmentally sound
manner.
This appliance is labelled in accordance with Euro-
pean Directive 2012/19/EU concerning used elec-
trical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as appli-
cable throughout the EU.
Please ask your specialist retailer about current
disposal facilities.
Subject to change without notice.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens DE18307M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens DE18307M in the language / languages: English, German, Dutch, French, Polish, Polish as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info