652251

Siemens DE08111M Manual

15
Zoom out
Zoom in
Previous page
1/56
Next page
15
en
III.
Wall mounting
Undersink appliances
■ Attach mounting template D to the wall.
■ Mark the locations for the holes; drill the holes
and insert the wall plugs.
■ Attach the installation bracket to the wall using
the screws (D1).
Only for permanently installed appliances:
■ Pass the connection cable through the cable
grommet, suspend the appliance in the instal-
lation bracket and screw it onto the mounting
bracket (D2).
Only for appliances with mains plug:
■ Suspend the appliance in the installation bracket
and screw it onto the mounting bracket (D3).
Over-sink appliances
■ Attach mounting template E to the wall.
■ Mark the locations for the holes; drill the holes
and insert the wall plugs.
■ Attach the installation bracket to the wall (E1).
■ Pass the connection cable through the cable
grommet, suspend the appliance in the instal-
lation bracket and screw it onto the mounting
bracket (E2).
Only for DE05101M, DE06101M,
DE06111M, DE08101M and DE08111M
(fixed electrical connection)
■ The variants for feed through of cables using
flush mounting electrical connection should be
observed on the mounting template.
■ The cable grommet must completely enclose the
connection cable to guarantee optimum protec-
tion against dampness. The opening must be
sealed watertight if it is damaged.
■ Use the openings provided on the rear for
mounting.
IV.
Water connection
Left: pressurised (closed);
right: unpressurised (open)
■ The appliance is only approved for heating water
with a specific electric resistance of ≥ 1 300 Ωcm
at 15 °C. Your water utility company can give you
information about the specific water resistance.
Installation
■ Ensure the axial fit of the connection pipes in the
nozzles.
■ Tighten the union nuts on the nozzles with an
open-end wrench and counter hold with a suit-
able open-end wrench.
■ The T-piece (for the pressurised connection)
and flexible connection hose are available
commercially.
■ Only the approved unpressurised valves may be
used when connecting without pressure (Special
accessories: Single-lever mixer tap BZ13062,
Two handle fixture BZ13051).
■ Exchange the perlator from the tap fixture with
the supplied aerator to change the spray pattern
of the tap.
Controlling temperature
The supply temperature (probably lower in winter)
and pressure fluctuations can influence the tem-
perature of the water leaving the tap.
■ Turn the valve slowly in the closed direction for
higher temperatures (F1).
■ Add cold water for lower temperatures (F2).
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens DE08111M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens DE08111M in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 2,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info