637073
63
Zoom out
Zoom in
Previous page
1/71
Next page
NL
-VOOR TOESTELLEN MET INGEBOUWDE
CONTACTDOOS
Deze stofzuiger is uitgerust met een ingebouwde elektrische
aansluiting waarmee elektrisch gereedschap (circulaire zaag,
boor, schuurmachine, enz. ..) direct kan worden aangesloten
op de afdekinrichting, en een automatische functie voor het
inschakelen van gereedschap, ten behoeve van een schone
werkomgeving.
!WAARSCHUWING! Sluit geen gereedschap of apparaat aan
op de elektrische aansluiting van de stofzuiger dat meer
vermogen behoeft dan het maximale vermogen voor de
contactdoos, zoals vermeld in de graek hierboven.
Controleer wat het nominale vermogen is op het typeplaatje
van het gereedschap. Om het risico op letsel te verminderen,
dient het gereedschap uitgeschakeld te zijn voordat de
schakelaar in de (=) AUTO-stand wordt gezet. (HET TOESTEL
MAG NOOIT ONBEMAND ACHTERGELATEN WORDEN TERWIJL
HET WERKT OF DE STEKKER ERVAN IS AANGESLOTEN).
De aan/uit-schakelaar wordt gebruikt om de in de stofzuiger
ingebouwde automatische functie voor het inschakelen van
het gereedschap te selecteren. Indien de (–) ON-stand gekozen
wordt, werkt de stofzuiger gewoon onophoudelijk Wanneer de
(=) AUTO-stand wordt gekozen, wordt de stofzuiger automatisch
in- en uitgeschakeld wanneer het gereedschap wordt in- en
uitgeschakeld.
Het gereedschap moet minimaal 60 Watt gebruiken opdat de
automatische functie voor het inschakelen van gereedschap
werkt. Het maximale vermogen voor de elektrische aansluiting
staat aangegeven in de bovenstaande graek.
Til het kapje op de contactdoos op om toegang te verkrijgen tot
de aansluiting. Indien de stekker die u gebruikt niet overeenkomt
met de aansluiting, probeer dan geen modicaties aan te
brengen aangezien dit gevaarlijk kan zijn en de garantie ongeldig
maakt.
REPARATIE OF VERVANGING VAN ONDERDELEN
Voer nooit enig onderhoud uit aan het toestel, tenzij de stekker
van het netsnoer niet in het stopcontact zit.
Deze toestellen bevatten elektrische componenten die
vervangen kunnen worden. Het wordt aanbevolen dat
reparatie of vervanging van onderdelen wordt uitgevoerd
door een bevoegde monteur. Gebruik alleen originele
vervangingsonderdelen die aanbevolen worden door de
fabrikant.
Indien de contactdoos los, kapot of beschadigd raakt, of indien
de heldere bescherming van de schakelaar beschadigd zou
raken of ontbreekt, neem het toestel dan uit gebruik en laat het
repareren.
ES
-PARA UNIDADES CON RECEPTÁCULO
INCORPORADO
Esta aspiradora está equipada con un enchufe eléctrico
incorporado que permite que una herramienta eléctrica
(sierra circular, perforadora, pulidora, etc.) se pueda enchufar
directamente al montaje de la cubierta. Asimismo, presenta
una función de disparador automático de herramienta para un
entorno de trabajo limpio.
¡
ADVERTENCIA! No conecte al enchufe eléctrico de la
aspiradora a ninguna herramienta o artefacto con un
régimen nominal superior al del receptáculo como se observa
en la tabla de más arriba.
Verique la placa de identicación de la herramienta para ver
cuál es el régimen nominal de vatios. Para reducir el riesgo
de lesiones, la herramienta debe apagarse (O) antes de
colocar el interruptor en la posición de automático (AUTO).
(NUNCA DEJE LA UNIDAD FUNCIONANDO O CONECTADA SIN
SUPERVISIÓN DIRECTA).
Este interruptor se utiliza para seleccionar la función de
disparador automático de la herramienta incorporado en la
aspiradora. Con la posición de encendido (-) (ON) seleccionada, la
aspiradora simplemente funcionará de manera continua. Cuando
se seleccione la posición automática (=) (AUTO) la aspiradora se
encenderá y apagará automáticamente cuando la herramienta
eléctrica se encienda o apague.
Para que el disparador automático de la herramienta funcione,
la herramienta eléctrica debe recibir por lo menos 60 vatios.
El régimen nominal máximo para el enchufe eléctrico está
clasicado en la tabla de más arriba.
Eleve la cubierta en el receptáculo de clavija para acceder al
enchufe. Si el enchufe que está insertando no es adecuado
para la construcción del enchufe, no intente realizar ninguna
modicación ya que esto podría ocasionar un riesgo y anulará
la garantía.
REPARACIÓN O REEMPLAZO DE PARTES
230 Volt 230 Volt 230 Volt
Voltage 50Hz 50Hz 50Hz
Max.
vermogen van
de motor
Max.
vermogen van
de contactdoos
1400 1600 1800
1600 1400 1200
230 Volt 230 Volt 230 Volt
Voltaje 50Hz 50Hz 50Hz
Vataje máximo
desde el motor
Vataje máximo
desde el
receptáculo
1400 1600 1800
1600 1400 1200
63


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ShopVac Classic 30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ShopVac Classic 30 in the language / languages: All languages as an attachment in your email.

The manual is 18,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info