657082
14
Zoom out
Zoom in
Previous page
1/20
Next page
5/11/2007
14
BATTERIES AND BATTERY CHARGING
The Shoprider® Start 8 Portable scooter is supplied with maintenance-free, sealed lead
acid batteries. For easy handling, the batteries are contained within a battery pack. Battery
life and performance may be affected by temperature, terrain, condition of battery, the
weight of the user, care of batteries, and other conditions. The battery needle gauge is
only a guide and is most effective when the scooter is moving, only then is the true
discharge level displayed.
x When the scooter stops the battery needle gauge may indicate full.
x An active user can use up to 30% of battery capacity or more per day.
x Inactive users may only use 50% of battery capacity in a week.
x In both these instances the battery should be put on charge over night.
**Keeping the batteries charged at all times will extend the life of the batteries**
Battery Charger
The battery charger is a 3-amp transformer type off board. The Start 8 Portable scooter has
a built in charger port on the rear side of the battery pack. This special feature allows the
batteries within the battery pack to be charged without the scooter.
First Time Use
Prior to using your Start 8 Portable scooter for the first time, you must charge the batteries
fully (refer to Battery Charging Procedures). Charging may take up to 12 hours. Charging
the batteries completely prior to first time use will benefit battery efficiency. Failure to do so
may cause damage.
Charging
To charge the batteries connect the 3-pin male plug lead into the 3-pin female battery-
charging socket located on the battery pack. Plug the A/C cord plug into the wall socket.
The battery charger has two indicator lights. The red light, when solid, indicates power on.
A flashing red light indicates a problem in the connection to the batteries. If the red
charging light flashes when plugged into the battery pack, check the reset button and
batteries for excessive discharge. The green light, when flashing, indicates the batteries are
charging. When the green light becomes solid, the charging cycle is complete. Once the
batteries are completely charged, unplug the A/C cord from the wall then unplug the 3-pin
lead from the battery pack. Remember to always remove charger once charging cycle is
complete.
WARNING: Only use the original Shoprider approved charger!
This charger is for indoor use only. DO NOT expose it to rain or water spray.
Do not leave the charger plugged into the charger port if the charger is not charging.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Shoprider GK9 Start 8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Shoprider GK9 Start 8 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info