ENGLISH
13
Repeat the above steps 1 to 3 to memorize
other stations.
4
After selecting the tuner as an input
source, select the preset mode.
1
Listening to FM stereo broadcasts
When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
The station has now been stored in the memory.
When using the NUMERIC buttons, the station is
stored automatically without pressing the MEMORY
button.
A stored frequency is erased from the memory by
storing another frequency in its place.
If “MEMO” goes off, start again from the above step 2.
Then “CH” lights up.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
INPUT SELECTOR settings
Preset stations,etc.
Note
If the electricity fails or the AC input cord is
disconnected for more than 2 weeks, they are all
cleared. So you should memorize them again.
While listening to FM broadcasts.
Each time this button is pressed,
the FM mode changes as follows:
Stereo mode : “STEREO” lights up.
Mono mode : “STEREO” goes off.
When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode to
reduce the noise, then FM broadcasts are reproduced
in monaural sound.
Scanning preset stations in sequence
The receiver will start scanning the stations in the preset
sequence and each station is received for 5 seconds.
At the desired station, press this button again to stop
scanning.
When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
mode.
Tuning to preset stations
Select the desired preset number.
2
Select the desired preset number (1~30) and
press the MEMORY button.
3
