ENGLISH
16
When CD, VIDEO 1~ 2 is selected as an input source
• When playing back the program sources with surround
sound, refer to “ENJOYING SURROUND SOUND” on
page 19.
• Each time this button is pressed, the corresponding input
is selected as follows:
o(ptical) c(oaxial)1 c(oaxial) 2 A(nalog)
Notes :
• When F AUX, TAPE, BT IN, EXT IN or tuner is selected as
an input source, the digital input cannot be selected.
• When the selected digital input is not connected, the
"DIGITAL" indicator flickers and the analog input is
automatically selected.
• The selected digital or analog input is automatically
assigned to the corresponding input source on the INPUT
setup menu. (For details, refer to "SETTING THE INPUT "
on page 33.)
• The sound from the component connected to the selected
digital input can be heard regardless of the selected input
source.
• “MUTE” will flicker.
• To resume the previous sound level, press it again.
4. Select the digital or the analog input connected
as desired.
7. To mute the sound.
5. Operate the selected component for playback.
6. Adjust the (overall) volume.
• Be sure to switch the speakers off.
• When listening to a DTS or Dolby Digital program source,
if the headphones are plugged in and the SPEAKER
button is set to off, it enters the 2CH downmix mode
automatically. (For details, refer to "2CH downmix mode"
on page 19.)
Note :
• Be careful not to set the volume too high when using
headphones.
8. To listen with the headphones.
