• Depending on your speaker type, you can select one of
these following speaker types.
L(Large): Select this when connecting speakers that can
fully reproduce sounds below crossover frequency.
S(Small) : Select this when connecting speakers that can
not fully reproduce sounds below crossover
frequency. When this is selected, sounds below
crossover frequency are sent to the subwoofer
or speakers which are set to "L (Large)" (when
not using a subwoofer)
N(None): Select this when no speakers are connected.
When this is selected, sounds are sent to the
speakers which are not set to "N (None)".
Y(Yes)/N(No): Select the desired depending on whether a
subwoofer is connected or not.
Notes :
• When speakers are set to "S (Small)", you should set
their crossover frequency correctly according to their
frequency characteristics. (For details, refer to "When
selecting the CROSSOVER" on page 35.)
• When "SUB-W" is set to "N (No)", "FRONT" is
automatically set to "L (Large)".
• When the "FRONT" is set to "S (Small)", "CENTER" and
"SURR" cannot be set to "L (Large)".
33
3. Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to
set the selected speaker as desired.
4. Repeat the above steps 2 and 3 until the speakers are all set to the desired mode.
About the speaker size
• Select "L (Large)" or "S (Small)" not according to the actual size of the speaker but according to the speaker's capacity for
playing low frequency (bass sound below frequency set on the "X-OVER" menu) signals.
• If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage
the speakers) to determine the proper setting.
2. Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired speaker.
ENGLISH
When selecting the CONFIGURATION
1. Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the "CONFIG", then press the ENTER button.
