E-12
Factory reset, clearing all memory■
Care of compact discs■
Maintenance
Cleaning the cabinet■
Periodically wipe the cabinet with a soft cloth and a
diluted soap solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint
thinner, etc.). It may damage the cabinet.
Do not apply oil to the inside of the unit. It may cause
malfunctions.
●
●
Troubleshooting chart (continued)
USB■
Symptom Possible cause
Device cannot be
detected.
● Is there any MP3/WMA file
available?
Is the device properly
connected?
Is it an MTP device?
Does the device contain
AAC file only?
●
●
●
●
Playback does not
start.
● Is it a copyright protected
WMA file?
Is it a false MP3 file?
●
●
Wrong time display.● Is Variable Bitrate file
being played back?
●
Condensation■
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet (CD pickup, etc.) or on the transmitter
on the remote control. Condensation can cause the unit
to malfunction. If this happens, leave the power on with
no disc in the unit until normal playback is possible (about
1 hour). Wipe off any condensation on the transmitter with
a soft cloth before operating the unit.
Before transporting the unit■
Remove the disc and USB memory device from the unit.
Then, set the unit to the power stand-by mode. Carrying
the unit with USB memory device left connected or disc
left inside can damage the unit.
NO YES
Correct
If problem occurs■
When this product is subjected to strong external
interference (mechanical shock, excessive static
electricity, abnormal supply voltage due to lightning, etc.)
or if it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
Set the unit to the stand-by mode and turn the power
on again.
If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn the
power on.
Note:
If neither operation above restores the unit, clear all the
memory by resetting it.
1�
2�
Press the ON/STAND-BY button to enter the power
stand-by mode.
While pressing down the VOLUME + button, press
button. “rSt” appears.
Caution:
This operation will erase all data stored in memory
including tuner preset, and CD program.
1
2
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
Keep your discs away from direct sunlight, heat, and
excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre,
along the radius.
●
●
●
