572902
108
Zoom out
Zoom in
Previous page
1/112
Next page
Appendix
Appendix
93
Playback mode
Card mode
General
Symptom
Cannot play back, rewind
or fast forward tape.
Video noise in image.
Cannot delete image
on SmartMedia card.
Cannot format
SmartMedia card.
Cassette will not eject.
Viewfinder picture is
hard to see.
LCD monitor picture is
hard to see.
Cannot edit to con-
nected video equipment.
Remote control does
not function.
Possible cause
Position at beginning or end of
tape.
Dirty video heads.
Old or worn tape.
Write-protect seal is affixed to card.
Image is delete-protected.
Write-protect seal is affixed to card.
Power source is not properly
connected.
Battery pack is not charged.
Camcorder is recording.
Viewfinder dioptre is not properly
adjusted.
Inappropriate picture adjustments.
Audio/video or DV cable is not
properly connected.
REMOTE menu item is set to
OFF.
Remote control battery has run
down.
Remote control used beyond
operating range.
Intense daylight falling on
camcorder remote sensor.
Obstacle between remote control
and camcorder remote sensor.
Suggested solution
Rewind or fast forward tape to
desired point (p. 23).
Call for service, or use a commer-
cially available video head
cleaning tape (p. ix).
Use a new cassette.
Remove write-protect seal (p. 88).
Cancel the protection setting
(p. 79).
Remove write-protect seal (p. 88).
Connect power source properly
(pp. 10, 11).
Charge battery pack sufficiently
(p. 9).
Stop tape and try again (p. 20).
Adjust dioptre (p. 18).
Adjust picture (p. 64).
Connect audio/video or DV cable
properly (pp. 65, 66).
Set REMOTE menu item to ON
(pp. 43, 44).
Replace remote control batteries
with new ones (p. 43).
Use remote control within operating
range (p. 44).
Protect remote sensor from
exposure to intense daylight (p. 44).
Remove obstacle or use remote
control from different angle (p. 44).
Notes:
This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical
noise or interference. If this should happen, turn off the power and disconnect the unit from any power
sources, including the lithium battery, etc. Then reconnect the power sources to resume operation.
If the characters displayed in the viewfinder or on the LCD monitor appear to malfunction, disconnect the
power source and remove the lithium battery, then reconnect the power source, insert the lithium battery, and
turn the power on again. The characters should be normal. Set the date and time, then resume operation.
108


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp VL-WD450S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp VL-WD450S in the language / languages: English as an attachment in your email.

The manual is 8,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sharp VL-WD450S

Sharp VL-WD450S User Manual - German - 112 pages

Sharp VL-WD450S User Manual - Dutch - 109 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info