19047
23
Zoom out
Zoom in
Previous page
1/64
Next page
23
SD-AS10
DVD Operation
- Inserting and removing discs -
Caution:
! Do not touch the disc compartment while it is moving, and be careful not to pinch
your fingers.
! If the power fails while the compartment is open, wait until the power is restored.
! If the disc compartment is stopped with force, the unit will not function. If this
occurs, press the POWER button to enter the power stand-by mode and then turn
the unit on again.
! Do not insert two discs in one disc insertion slot.
! A disc with scratches or fingerprints may not play properly. Refer to "Care of discs
(page 62)" and clean the disc.
! Do not play the discs of special shapes (heart or octagon shaped) as they can be
ejected while rotating and cause injury.
! If you turn off the power with the disc compartment open, the compartment closes.
" To remove the disc
" To exchange other discs while playing a
disc
5 Insert a disc into the disc insertion slot and push it.
The disc compartment closes automatically.
Disc insertion angle differs depending on the installation direction.
1. Insert a disc into the slot with the label
toward you.
2. Push in the disc slightly (it enters auto-
matically).
3. The disc compartment closes and one
of the DISC 1 - DISC 5 buttons lights up
for the disc.
6 Repeat steps 3 - 5 to insert a disc into the DISC 2 - 5 slot.
Disc insertion slot
Label side
Push
Example: Removing a disc from DISC 1
1 Press the DISC 1 button.
The same operation can be performed by pressing the DISC SELECT button, and
then press the DISC 1 button on the remote control.
2 Press the OPEN/CLOSE button.
The same operation can be performed by pressing the button on the remote
control.
3 Remove the disc.
4 Press the OPEN/CLOSE button to close the disc compartment.
The same operation can be performed by pressing the button on the remote
control.
To remove more discs, repeat step 1 - 4.
Notes:
! DVD discs cannot be removed in the resume
play mode. Press the STOP button and
then remove the disc.
! Do not touch the playback side.
! 3" (8 cm) discs are not supported.
1 Press a disc number select button (except for the disc in operation).
The same operation can be performed by pressing the DISC SELECT button and
then the disc number select button on the remote control.
2 Press the OPEN/CLOSE button.
The same operation can be performed by pressing the button on the remote
control.
3 Replace a disc.
YES
5" (12cm)
NO
3" (8cm)
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp SDAS10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp SDAS10 in the language / languages: English as an attachment in your email.

The manual is 6,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info