33893
9
Zoom out
Zoom in
Previous page
1/102
Next page
8
QUICK REFERENCE
TV GUIDE ON SCREEN™ QUICK SETUP SHEET
Once you set up the TV according to this operation manual, you are ready to set up TV Guide On Screen!
Note: TV Guide On Screen™ interactive program guide supports cable-ready, cable box and digital cable
services as well as over-the-air broadcast. It does not provide listings for satellite services.
After completing the TV’s initial setup, you see the TV
Guide On Screen Setup Welcome Screen.
Note: If TV Guide On Screen is not set up, pressing TV
GUIDE while watching TV will display the Welcome
Screen.
Follow the on-screen instructions
If you previously skipped TV Guide On Screen setup,
you see the Reminder Screen.
Note: If you press ENTER and the screen does not
change, make sure that the batteries in the remote
control are properly installed.
If you need to control a cable box and/or a VCR,
complete steps 1 through 3. If not, go to step 4.
1
2
Find and Connect the included G-LINK cable
into the G-LINK terminal.
Find the VCR and Cable Box IR Sensors.
To control recording, find the VCR's IR sensor.
1 Turn the VCR off.
2 Hold the VCR remote so that it touches the
front of the VCR (Figure 1).
3 Move the remote across the front while
pressing POWER (Figure 2). (You must press
and release the power button each time you
move the remote; holding down the button will
not work).
4 When the VCR powers on, you have found
the sensor.
5 Remember the location of the sensor, and go
to step 3.
If you have a cable box, repeat this procedure
using the cable box and its remote, and then
go to step 3.
G-LINK cable with
Double-Sided Tape
Place the G-LINK cable(s)
To control a VCR, place one of the G-LINK
cables underneath the VCR approximately 1
inch in front of the sensor you found in step 2.
If you have a cable box, place the other G-
LINK cable approximately 1 inch in front of
the sensor you found in step 2.
Use the double-sided tape to secure each
G-LINK cable.
4
3
Use the TV remote for On-Screen Setup
1 Press a/b/c/d and ENTER to highlight an
item in a Setup screen.
2 Press ENTER to select that item.
a/b/c/d
ENTER
G-LINK cable
Figure 1
Correct Incorrect
Figure 2
G-LINK
cable
This end is connected to the TV as
shown in step 1.
1 inch
VCR
or
Cable Box
G-LINK wand
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp LC32D5U at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp LC32D5U in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info