49795
33
Zoom out
Zoom in
Previous page
1/136
Next page
33
Advanced Operations / Усовершенствованные операции
Charging the battery pack
— CCD-TR3300E only
After connecting the mains lead to the mains and
setting the POWER switch on the camcorder to
OFF, you can charge the battery pack in either of
the following two ways:
(When charging begings, the CHARGE lamp
lights.)
Charging the battery attached to the camcorder
Leave the battery pack attached to the
camcorder. (The NP-F530 battery pack requires
about 210 minutes for a full charge and about
150 minutes for a normal charge.)
Charging two battery packs at the same time
Attach one battery pack to the AC power
adaptor and other to the camcorder. Both are
charged simultaneously. When charged, both
lamps go out (normal charge). If either lamp is
still lit, both batteries are not charged (the NP-
F530 battery packs require about 240 minutes
for a full charge and about 180 minutes for a
normal charge).
You can also charge the battery pack in either of
the above two ways by connecting the AC power
adaptor to the Handycam Station and setting the
HANDYCAM POWER switch to OFF.
Notes on the VTR/CAMERA lamp
The VTR/CAMERA lamp will remain lit for a
while even if the unit is unplugged after use.
This is normal.
If the VTR/CAMERA lamp does not light,
disconnect the mains lead. After about 1
minute, reconnect the mains lead.
To remove the connecting plate
Pull out the connecting plate by the plate. Never
pull the connecting cord itself.
Зарядка батарейного блока
— только модель CCD-TR3300E
После подсоединения сетевого провода к
электрической сети и установки
переключателя POWER на видеокамере в
положение OFF Вы можете производить
зарядку батарейного блока одним из
следующих способов:
(Когда начнется зарядка, высветится
лампочка CHARGE.)
Зарядка батарейного блока,
подсоединенного к видеокамере
Оставьте батарейный блок,
подсоединенным к видеокамере. (Для
батарейного блока NP-F530 требуется
около 210 минут для полной зарядки и
около 150 минут для нормальной зарядки.)
Зарядка двух батарейных блоков
одновременно
Подсоедините один батарейный блок к
сетевому адаптеру, а другой к
видеокамере. Оба батарейных блока будут
заряжаться одновременно. По окончании
зарядки обе лампочки гаснут (нормальная
зарядка). Если одна из лампочек горит, оба
батарейных блока еще не заряжены (для
батарейных блоков NP-F530 требуется
около 240 минут для полной зарядки и
около 180 минут для нормальной зарядки).
Вы также можете заряжать батарейный
блок одним из вышеописанных способов,
подсоединив сетевой адаптер перем. тока к
станции Handycam и установив выключатель
HANDYCAM POWER в положение OFF.
Примечания к лампочке VTR/CAMERA
Лампочка VTR/CAMERA будет оставаться
горящей еще в течение некоторого времени,
даже если аппарат отсоединен от сети
после использования. Это является
нормальным.
Если лампочка VTR/CAMERA не горит,
отсоедините сетевой провод.
Приблизительно через одну минуту снова
подсоедините сетевой провод.
Для снятия соединительной пластины
Вытащите соединительную пластину,
потянув за саму пластину. Никогда не тяните
за соединительный шнур.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp CCD-TR2300E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp CCD-TR2300E in the language / languages: English as an attachment in your email.

The manual is 2,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info