17525
57
Zoom out
Zoom in
Previous page
1/68
Next page
55
OPTIONAL
EQUIPMENT
SINGLE PASS FEEDER (AR-SP2)
Using the SPF
Be sure to remove any staples or paper clips from the
originals.
Damaged or crumpled originals may misfeed in the SPF.
It is recommended that these originals be copied from the
original table.
Before placing curled or wavy originals into the document
feeder tray, be sure to flatten them. If not, original misfeeds
may result.
For best feeding of originals which have binding holes
punched into them, insert them so that the holes are
positioned to the right or along the side guides.
Special originals such as transparency film and tracing
paper should not be fed through the SPF but should be
copied from the original table.
Single pass feeder (AR-SP2)
Stream feeding mode
If the stream feeding mode has been enabled using user program
No. 4, the SPF indicator will continue to blink for approximately
5 seconds after feeding of all originals is completed. While this
indicator is blinking, any new originals placed in the SPF will be
fed and copied automatically. See page 35, USER PROGRAMS.
1
Ensure that no original is left on the original table.
2
Adjust the original guides to the size of the originals.
3
Set the originals face up in the document feeder tray.
The SPF indicator will light up. If this indicator does not light up, the
originals are not properly set or the SPF is not properly closed.
4
Ensure that the copy paper size in the paper tray is the
same size as the originals.
5
Press the START key.
Since only one copy per original can be made, the number of copies
cannot be changed.
Press the CLEAR key to stop copying in the middle of a run.
While making copies from the SPF, do not place
originals of the next copying job. Place them after all
copies of the current job have been output.
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp AR162S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp AR162S in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info