743709

Shark ION Robot RV750 Series Manual

6
Zoom out
Zoom in
Previous page
1/16
Next page
9 101-800-798-7398 sharkclean.com
ENGLISH
IMPORTANT: Install
the charging dock in a
location that can be easily
accessed by your Shark
ION ROBOT.
Always keep the charging
dock plugged in, or the
Shark ION ROBOT will not
be able to automatically
return to the base.
The Shark ION ROBOT
will beep when it is first
connected to power or
when it starts charging on
the dock.
RECYCLING YOUR
BATTERY
When your robot’s battery
needs to be replaced, dispose
of it or recycle it in accordance
with local ordinances or
regulations. In some areas,
it is illegal to place spent
lithium-ion batteries in the
trash or in a municipal solid
waste stream. Return spent
batteries to an authorized
recycling center or to retailer
for recycling. Contact your
local recycling center for
information on where to drop
off the spentbattery.
CHARGING YOUR SHARK ION ROBOT™
INSTALLING THE CHARGING DOCK
Set the charging dock on a hard, level surface, with its back
against the wall. Remove any objects that are closer than 3 feet
(1 meter) from either side of the base, or closer than 5 feet
(1.52 meters) from the front of the base. Plug the charging
cable into the port on the side of the dock, and connect the
charger plug to a wall outlet.
IMPORTANT CHARGING INFORMATION
The Shark ION ROBOT has a pre-installed rechargeable battery.
Battery must be fully charged before using. The Power switch
must be in the ON position in order to charge the battery.
When the cleaning cycle is complete or the battery is running
low, Shark ION ROBOT will automatically return to the charging
dock.
If your unit doesn’t return to the dock, the battery charge may
have run out. See charging instructions on page 10.
Shark ION ROBOT™ can be charged
three dierent ways:
1 Manually place Shark ION ROBOT on the
charging dock, aligning its charging pads
with the charging contacts on the base.
2 Using the app, press the DOCK button to
automatically send Shark ION ROBOT to
the charging dock.
3 To charge unit directly, plug the charger
into a wall outlet, then connect the charger
cable to the jack on the side of the Shark
ION ROBOT.
BATTERY CHARGE INDICATOR LIGHTS
While the battery is charging, all three blue
LED lights will cycle until fully charged.
As the unit cleans, its battery discharges.
The blue lights indicate how much charge is
remaining.
If the red “Replace” light is on, then the battery
needs to be replaced. See page 20 for more
information. If all the battery indicator lights
are off, then either the power switch is turned
off or there is no charge remaining. Turn the
Power switch to the ON position. If all indicator
lights remain off, then charge the unit directly,
using the charger.
5 ft.
3 ft.
3 ft.
✕
Clean
!
Spot
Dock
Replace
!
Replace
Clean
Spot
Dock
Cycles While Charging
Full Charge
Low ChargeMid ChargeNearly FullFull Charge
Cycles While Charging
Full Charge
Low ChargeMid ChargeNearly FullFull Charge
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Shark ION Robot RV750 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Shark ION Robot RV750 Series in the language / languages: English as an attachment in your email.

The manual is 2,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info