489203
26
Zoom out
Zoom in
Previous page
1/32
Next page
Back-up Camera
Installation
- 25 -
T
o
F
m
8. Next you will need to find the vehicle’s reverse lights. Turn the vehicle’s ignition key
to the accessory position, engage the parking brake and put the car in reverse.
Look at the vehicle’s tail lights to see where the reverse lights are located.
o locate the reverse light’s +12V wire it will be necessary to gain access to the rear
f the vehicle’s tail light.
or help locating the vehicle’s reverse light circuit contact your vehicle’s
anufacturer for vehicle specific wiring diagrams.
Fig 6
9. Once you have located the reverse light circuit you
will have to route the camera’s power cable to that
location. You must securely fasten the power cable
to prevent it from being caught on any vehicle
component such as the trunk hinge (Fig.6). Never
route the cable on the outside of the vehicle.
10. The sockets for most vehicle’s reverse lights have two wires connected to them.
One is positive and one is negative, to determine which is positive you will need at
least a 12V test light or a multi-meter.
11. After determining which wire is the positive and which is the negative, turn off the
ignition key, then remove the battery’s negative cable.
12. Following the Scotch- Lok
TM
instructions, splice the Red wire using the in-line
Scotch-Lok
TM
wire connectors to the reverse light’s positive (+) wire. Use a set of
slip joint pliers to squeeze the TAP and insure good connection. ( For details refer to
below figure )
13. Then splice the black wire of the camera’s power cable to the reverse light negative
(-) wire or ground.
14. Secure all the wires with cable ties or electrical tape. Re-attach the negative battery
cable to the battery.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sevic TRAVEL LIBERTY 7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sevic TRAVEL LIBERTY 7 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info