placed on a heat-resistant surface,
impervious to splashes and stains. Do not
position the appliance on or near hot
surfaces, open flames or inflammable
vapours.
● Do not allow the power cord to touch
hot surfaces.
● Do not let the power cord hang free.
● Always switch off and remove the plug
from the wall socket
- after use, as well as
- in cases of malfunction, and
- during cleaning.
● When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is intended for domestic
use only and not for commercial
applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Temperature control
With the temperature control knob, the
temperature can be set to the desired level.
4-position switch settings
● No setting selected
Upper heat
Lower heat
Upper and lower heat
The heating elements will only come on
once the timer is activated.
Timer
The timer can be used for either selecting a
certain cooking time (up to 60 minutes). To
turn the unit off, turn the switch to position
0. To pre-programme the cooking time, turn
the switch clockwise to the desired time.
To set a time of less than 10 minutes, turn
the timer to a somewhat higher setting first
and then slowly turn it back to the desired
time setting. After the pre-programmed time
has elapsed, an acoustic signal indicates that
the heating elements are switched off. To
switch off the entire appliance, the heating
elements must be switched off as well.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once the
pre-programmed time has elapsed, or if the
switch is turned back to position 0.
Start up
-
Clean the appliance (see General care
and cleaning) and remove any packing
materials completely.
-
Before using the appliance for the first
time, let it heat up for 15 minutes with
both heating elements on. When the
appliance is first switched on, a slight
smell may be emitted. This is normal and
will only last for a very short time. Ensure
sufficient ventilation.
Operation
-
Before using the appliance, make sure
that the crumb tray is fitted in its proper
position underneath the lower heating
element.
-
Pre-heat the oven compartment for
several minutes with the door closed,
using both heating elements. Set the
temperature control knob to the required
level and use the timer control to select
the desired pre-heating time.
-
Place the food to be cooked on the grill
rack. When cooking food containing fat
or moisture, use the baking tray to stop
any drips into the interior of the
appliance.
-
Close the door, set the temperature
control to the required level and use the
9
