12
children.
∙ Children must not be
permitted to play with the
appliance.
∙ Caution: Keep any packaging materials
well away from children – these materials
are a potential source of danger, e.g. of
suffocation.
∙ Every time the appliance is used, the
main body including the power cord as
well as any attachment fi tted should
be checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, or if
excessive force has been used to pull the
power cord, it must no longer be used:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
∙ The appliance should only be placed on a
level surface. Do not allow the housing or
its power cord to come into contact with
open fl ames or any hot surfaces such as
hot-plates.
∙ Do not let the power cord hang free.
∙ Do not touch any moving parts during
operation - this can be extremely
dangerous.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, the blender jug and lid with stopper
should be thoroughly cleaned as described
in the section Cleaning and care.
Switch settings
The following settings can be selected:
P The appliance remains switched on as
long as the rotary switch is held in this
position
0 The appliance is switched off
I Low power
II Maximum power
Short-term operation
The appliance is designed to process
average domestic quantities of food; it
can be operated without interruption for
a maximum of 3 minutes, after which it
should be allowed to cool down to room
temperature.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated if the blender jug is properly locked
in position.
Before removing the blender jug, make
sure that the rotary control is in position 0.
This also applies when fi tting the blender
jug to the motor housing. If the control is
not in its off-position (0), the motor will start
immediately.
Operation
∙ Fit the blender jug to motor housing, with
its handle to the right, in such a way that
the two triangle symbols are aligned.
∙ Put the ingredients into the blender jug.
The jug has a maximum capacity of 1000
ml. To avoid possible foaming or spilling
when processing foamable or thin liquids
such as milk, do not fi ll the jug over the
700 ml mark.
∙ Replace the lid so that the spout is
