-sta kitchens, o ces and other
commercial environments,
- agricultural areas,
- hotels, motels etc. and similar
establishments,
- bed-and-breakfast guest houses.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by quali ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service departments. e
addresses can be found in the appendix to
this manual.
Before using for the rst time
– Before the appliance is used for the
rst time, all detachable parts must be
thoroughly cleaned as described in the
section General care and cleaning.
Short-term operation
e appliance is designed to process
average domestic quantities of food. With
the blender or whisk attachments, it can
be operated without interruption for a
maximum of 60 seconds at settings I or II,
a er which it should be allowed to cool
down for approximately 5 minutes until it
has reached room temperature. When using
the chopping attachment, do not operate for
more than 10 seconds at settings I or II, a er
which it should be allowed to cool down for
approximately 5 minutes for the appliance to
cool down to room temperature.
Operating button
e blender is equipped with 2 push-type
operating buttons.
Operating button I: low power
Operating button II: high power
Blender operation
– When tting the blender attachment to
the drive unit, ensure that the arrow mark
and the open-lock symbol are aligned: to
lock, turn the blender attachment so that
the arrow on the drive unit is aligned with
the lock symbol on the attachment.
– Always use a suitable container for
operation. Any tall container with a at
base is suitable.
– Push the blender attachment down
into the ingredients in the bowl before
switching the unit on with the operation
buttons.
– Make sure that the attachments can rotate
freely inside the bowl and are not blocked
during operation.
– As soon as the operating button is
released, the blender will switch o .
Always wait until the motor has come
to a complete standstill before li ing the
blender attachment from the mixture.
– Remove the plug from the wall socket
a er use.
Attachments
Wait until the motor has come to a complete
standstill and remove the plug from the wall
socket before changing any attachments.
e attachments are tted to the drive unit.
Ensure that the arrow markings on the drive
unit and attachments are correctly aligned.
Chopping attachment
– Fit the cutting blade unit into the bowl
before lling the bowl with the food to
be chopped. Exercise extreme caution:
the blades are very sharp. When handling
the blades, always hold them by the upper
protective plastic covering.
– Position the lid on the bowl and lock it by
turning clockwise until it locks into place.
– Attach the drive unit to the lid of the bowl
and turn to lock; ensure that the arrow
and lock symbols are properly aligned.
– Insert the plug into the wall socket and
press the operating button in brief bursts
until the mixture has reached the desired
consistency. During processing, the lid and
bowl should be securely held in place.
– Avoid over lling the bowl; it may be
lled with herbs etc. up to the maximum
mark. Before the bowl is lled, the food to
9
