761637
21
Zoom out
Zoom in
Previous page
1/56
Next page
- 21 -
Transport of the appliance
During the transport, you have to
secure all loose parts in and on the
appliance, in order to prevent damage.
The appliance should not be trans-
ported in a vertical position and at the
same time not tilted over more than
30 degrees. Wait 30 minutes after the
installation, before you connect the
appliance to the mains.
If the appliance was transported with
a tilt of more than 30 degrees, wait 4
hours before you connect the appliance
to the mains.
Before the initial operation
Remove the protective sheets and all
packaging material incl. the transport
securing of the storage spaces and of
the trays from the appliance.
Dispose the packaging professionally.
You might notice a slight ‘new smell’
when you start the appliance for the
rst time. It goes away once the appli-
ance begins to cool.
Clean the interior with tepid water
with the addition of washing-up liquid.
Clean the equipment separately with
rinsing water, not in the dishwasher.
Before you ll the appliance with food,
let it work for 1 hour, so that the target
temperature can be reached. To make
sure your goods are fully frozen, wait
3 hours before taking them out of the
freezer.
Installation of the appliance
The appliance should be installed in a
dry and well-aired room.
The appliance can be operated at a
humidity of max. 70 %.
The surrounding temperature, at which
the appliance can be operated, can be
taken from the appliance specication
sheet at the end of this manual.
Do not install the appliance outdoors.
Bear in mind that you can pull the
power plug anytime.
Protect the appliance from direct inso-
lation. It should not be installed near
heat sources (stove, heater, etc.). If
this, however, cannot be avoided, you
should put isolation between the heat
source and the appliance.
You must not imbed the appliance in a
cabinet. The installation of the fridge
directly under a board or a cabinet is
disallowed.
The unevenness of the oor can be
compensated with the two vertically
adjustable screw-in feet in the front, so
that safe stability is attained.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin RKG 8935 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin RKG 8935 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info