Manual Severin RKG 8923 (page 22 of 48) (English, German, Dutch, French)

761524

Zoom out

Zoom in

1/48

- 22 -

•Atrst,setanaveragecoolingtemperature.

If the cooling is too strong, set a higher

temperature and if the cooling is too weak,

set a lower temperature.

If frost is built upon the back wall, then

the cause of this could be that the door

was opened too long, warm dishes were in

the appliance or the temperature was set

too low.

•Warm foods have to be cooled down to

room temperature before they can be

stored in the appliance.

•Make sure that the door is closed correctly

and that it is not blocked by cooled food.

Cleaning and Defrosting (Maintenance)

Cleaning

•Always pull the mains plug before clean-

ing.

•Do not pour water into the appliance.

•Tepid water with a bit of washing-up liquid

is suitable for the regular maintenance. In

order to avoid an unpleasant smell in the

cooling room, a cleaning of the latter once

a month is recommended.

•Clean the equipment separately with rins-

ing water, not in the dishwasher.

•Do not use aggressive, abrasive or alcoholic

detergents.

•After cleaning it with clear water, wipe the

surface and carefully dry it off. Subsequent-

ly, plug the mains plug with dry hands.

•In order to save energy and maintain the

efciency,youshouldcleanthecondenser

(on the backside) and the compressor at

least twice a year with a broom or vacuum

cleaner.

•The rating label in the interior of the appli-

ance cannot be damaged or even removed

while cleaning.

Defrosting

Defrosting the freezer

If the ice layer in the interior is 2-4 mm thick,

the freezer must be defrosted. Clean it at

least twice a year.

•Disconnect the mains plug from the socket.

•Remove food from the freezer and store it

as cool as possible, e.g., together with ice

packs and covered in a plastic recipient.

Please remember that the lifetime of the

goods is shortened by the temperature

increase and that they should be consumed

as quickly as possible.

•Leave the door open. To speed up defrost-

ing, place one or more pots with hot but

not boiling water in the freezer.

•Warning! Do not use other mechanical

devices or any other means, e.g., heating

appliances, to speed up defrosting.

•Dry the freezer thoroughly after cleaning.

•Plug in the mains plug. Wait approx. 5

minutes and set the temperature controller

to the desired position.

Defrosting the refrigerator

The refrigerator does not have to be defrosted

but it does have to be cleaned.

Therefrigerator‘sevaporatorisxedintothe

rear wall, which is why the rear walls can be-

come covered with frost. Whenever the com-

pressor is not working, frost can melt. The

resulting water is led through a hose system

to the basin on the compressor, where it then

evaporates due to the heat generated. When

setting the temperature controller, avoid per-

manent frost without a defrost phase.

Make sure that the drain gully and the drain

opening are not blocked so that the water

producedintherefrigeratorcanalwaysow

off unobstructed.

Tips for Energy Saving

•For the installation of the appliance, choose

a cool, dry and well-aired room.

•Protect the appliance from direct insolation.

It should not be installed near heat sources

(stove, heater etc.). If this cannot be avoid-

ed, some sort of isolation between heat

source and appliance has to be used.

•Don’t cover the ventilation openings and

grid. Provide enough circulation of air on

the backside of the appliance.

•Let warm food cool down before you store

it in the fridge.

•Do not leave the door open too long when

withdrawing or putting food inside. Other-

wise, the formation of ice in the interior will

be accelerated.

•Do not set the temperature lower than

necessary. More details on temperature

settings can be taken from the chapter

‘Controls and Display’.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin RKG 8923 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin RKG 8923 Manual

Product: