799274

Severin PG 8117 Manual

10
Zoom out
Zoom in
Previous page
1/52
Next page
10
142 x 208 mm
Before using for the rst time
∙ Remove any packaging materials and stickers from the
appliance.
∙Cleanthegrillrack,reectortrayandwind-guardwith
warm soapy water; wipe thoroughly dry afterwards.
∙ Assemble the appliance as described in Preparing the
unit.
∙ Let the grill heat up for approximately 10 minutes at
maximum power without any food (see ‘Boost-zone’
grilling). This will remove the smell typically encountered
whenrstswitchingonagrill.Alittlesmokemaybe
emitted; for that reason, adequate ventilation should
be ensured by opening windows or balcony doors; an
extractor hood is also suitable.
Grill assembly
∙ Assemble the grill as shown in the diagrams:
∙Placethereectortrayintothegrillhousing.
∙Fit the heating element with junction box into the
reectortray.Theapplianceisequippedwithasafety
switch. The unit can be operated only with the junction
box properly installed.
∙Fitthegrillracksothatthestudsontheracktintothe
correspondingopeningsinthereectortray.
∙Fitthewind-guardelementsrstattherearintothe
recesses on the grill rack, and then secure them on
the grill rack frame.
Base stand assembly
∙ For grill models with base stand, assemble the stand as
shown in the diagram:
∙Fit the four legs into the frame; ensure they are
locked.
∙Fit the storage rack into the corresponding recesses
in the legs.
∙Ensure that the stand is stable.
∙Place the assembled grill on top.
Preparing the unit
∙ Assemble the appliance as described in Grill assembly.
For grill models with base stand, refer to Base stand
assembly.
∙FillthereectortraywithwatertotheMax marking (max
900 ml). Do not pour water on the heating element or its
sensor.
Hint!
Duringgrilling,thewaterinthereectortrayshouldbe
replenished in good time. Caution: Always disconnect
theappliancefromthemainsbeforere-lling.
∙ Connect the appliance to the mains.
∙The unit is ready for use.
Grilling ‘Standard’ up to 320 °C
Togrillsausages,poultry,shetc.Fornishingorkeeping
warm steaks.
The entire grill surface is heated.
∙ Set the rotary control to the select the desired position
between min und •. The light ring shows steady
orange.
∙ Let the appliance heat up for around 10 minutes, and
then place the food on the grill surface.
Grilling ‘Boostzone’ 500 °C
For searing or light grilling of steaks.
The boost-zone is located to the right; the left side is
heated to approx. 320 °C.
∙Turn the rotary control to BOOSTZONE. The light ring
shows steady red.
∙ Let the appliance heat up for around 10 minutes, and
then place the food on the boost-zone.
∙ For subsequent cooking, lower the temperature or shift
the food to the left on the grill surface.
After grilling
∙ Always disconnect the unit from the mains and allow it to
cool down after grilling.
Cleaning and care
∙ Ensure that the grill is thoroughly cleaned after use.
∙ Before cleaning the grill, ensure it is disconnected from
the power supply and has completely cooled down.
∙ Do not use metallic pads or abrasive cleaning agents.
∙ Remove the wind-guard and grill rack and clean them
in a dish-washer or with warm soapy water. To remove
persistent food residues, they can be left soaking for a
while.
∙ Remove the heating element with the junction box. To
avoid the risk of electric shock, do not clean the heating
element with water and do not immerse it in water. The
junction box may be wiped with a slightly damp lint-free
cloth.
∙Takeoffthereectortrayandcleanitinadish-washer
or with warm soapy water. To remove persistent food
residues, it can be left soaking for a while.
∙All other parts can be cleaned with a cloth soaked
in soapy water, and should be wiped completely dry
afterwards.
Hint!
Tohelpcleanthewind-guard,grillrackandreectortray,
baking powder may be used. Mix a paste from water and
baking powder, rub the paste onto the affected areas
and let it take effect for a while. Clean with a soft brush/
sponge and rinse thoroughly afterwards.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin PG 8117 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin PG 8117 in the language / languages: All languages as an attachment in your email.

The manual is 1.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info