Manual Severin MW 7868 (page 18 of 132) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish)

654703

Zoom out

Zoom in

1/132

Cooking containers or utensils made of ‘Melamine’ plastic material absorb energy and are also unsuitable.

Using the microwave function

∙ Containers made from heat-resistant glass or porcelain, however, are well suited for use in microwave appliances.

∙ Plastic is suitable only if it is heat-resistant. Cooking bags etc. should be punctured to release any high pressure during cooking.

Cooking containers especially designed for use with microwave ovens are available at most kitchenware dealers.

∙ Cooking containers or plates can be tested for their suitability in a microwave appliance by placing the item (without any food) on

the glass turntable, switching the unit on, adjusting the microwave power setting to ‘High’, and letting the appliance operate for

approximately 20 seconds. Listen and watch carefully for crackling sounds and sparks. Should any be observed, switch the unit

off immediately. It is also important to check the temperature of the container: a suitable container will only be lukewarm.

Using the grill or hot-air function

∙ When using the grill or hot-air function, any heat-resistant containers or plates suitable for conventional ovens may be used. Do not

use plastic items when the grill or hot-air function is used.

∙ The food to be cooked can be put directly on the grill rack, which is then placed on the glass turntable.

Microwave/grill or microwave/hot-air combinations

∙ When using the microwave + grill or microwave + hot-air combinations, each function is activated alternately. The containers or plates

must therefore be suitable for use in a microwave as well as being heat-resistant. Because of the relatively high temperatures, plastic

items must not be used. Make sure that container or plate used does not contain any metal parts.

Operation

General information on programming the unit

To ensure optimum results, this microwave oven uses state-of-the-art electronics.

∙ When any control button is pressed, the correct input is acknowledged by one beep signal.

∙ While a programme sequence is running, the current setting can be called up by pressing the appropriate key. E.g., if during the

microwave programme the

key is pressed, the display will show the selected power setting.

∙ A programme can be interrupted or restarted by pressing the key

General operating sequence

∙ Place the food to be heated in a suitable container. Place the container onto the turntable in the oven.

∙ When food is placed in the microwave, it should be covered to prevent it from drying out. Glass or plastic covers especially

designed for use with microwave appliances are available at most kitchenware dealers.

∙ When using the grill, hot-air or any of the combination functions, do not cover the food to be cooked.

∙ When using the grill function, place the grill rack directly on the glass turntable and place the food on the grill rack.

∙ Close the door and set the desired programme.

∙ As the programme is started, the turntable starts to rotate. During operation, the interior light remains on.

∙ If a programme is not started within 5 minutes, the unit will automatically go back to Stand-by mode.

∙ If, during operation, the door is opened or the key is pressed (e.g. to stir or to turn the food in order to ensure that the

temperature is evenly distributed), the timer and programme functions are automatically suspended. The programme will

automatically resume only after the door is closed again and the key is pressed.

∙ Press twice to interrupt the programme.

∙ 5 beeps indicate that the pre-programmed period has elapsed; at the same time, the interior lighting switches off.

∙ Open the door and remove the container with the food.

∙ In order to achieve an even heat distribution through the food, the container should be set aside for several minutes.

Setting the clock:

Once the unit has been connected to the power supply, the display shows ‘0:00’ and an acoustic signal is heard.

Note: The time display does not start counting, unless the clock has been set. The time setting process can be cancelled by pressing

the key.

The clock must be set when the appliance is connected for the ﬁ rst time, and also if a power failure has reset the clock.

1. Press once or twice to select the 24- or 12-hour display. The display shows 24H or 12H.

2. Turn the rotary control to set the correct hour. The hour must be in the range 0-23 (for 24H) or 1-12 (for 12H).

3. Press . The minute digits start ﬂ ashing.

4. Turn the rotary control to set the correct minutes. The range must be 0-59.

5. Press to ﬁ nish setting the time. The symbol ‘:’ ﬂ ashes and the correct time is shown.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin MW 7868 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin MW 7868 Manual

Product: