Manual Severin KS 9954 (page 16 of 40) (English, German, Dutch, French)

712749

Zoom out

Zoom in

1/40

When de-frosting the freezer compartment

Once the build-up of ice inside the freezer compartment

has reached a thickness of 2-4 mm, it needs to be de-

frosted. This should be done at least twice a year.

∙ Ensure that the plug has been removed from the wall

socket.

∙ Remove all food from the compartment and store it in a

cool location, eg together with pre-frozen freezer-packs

in a closed plastic container. Note that, even with a

slight increase in temperature, the storage life will be

shortened and the food should be used as soon as

possible.

∙ Keep the door open. To accelerate defrosting, one or

several containers with hot (but not boiling) water may

be placed inside the freezer compartment.

∙ Warning: do not use any external device or other

means (e.g. heaters or heating fans) to accelerate de-

frosting.

∙ After cleaning, ensure that the freezer compartment is

thoroughly dried and set the temperature control to its

maximum position. After 24 hours, it may turned back to

its normal setting.

Defrosting the refrigerator cabinet :

The integral vapouriser is sealed in foam in the rear wall;

you may therefore notice a build-up of frost around the

rear area. This layer of frost will start melting when the

compressor is not working. Through a system of hoses,

the melt-water drains into the collection tray below the

compressor, where it will be absorbed into the surrounding

air. The unit does not therefore require de-frosting, but only

proper cleaning instead.

∙ To enable the melt-water to drain freely, always ensure

that the channel and discharge opening in the cabinet

are free of any blockage.

Energy saving tips

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers

etc.). If this cannot be avoided, however, suitable insulation

must be installed between the heat source and the unit.

∙ Do not cover the ventilation openings and grilles, and

ensure sufﬁ cient air circulation behind the unit.

∙ The compressor (at the rear) should be cleaned at

regular intervals. Accumulated dust causes an increase

in energy consumption.

∙ Warm food should be allowed to cool down before it is

stored inside.

∙ To prevent an increased build-up of ice, do not leave

the doors of the unit open for too long when loading or

taking out food.

∙ Frequent de-frosting helps to save energy. For detailed

information on cleaning the appliance, please refer to

the section De-frosting and cleaning.

∙ Do not set a lower-than-necessary temperature. For

detailed information on the temperature settings, please

refer to the section Temperature control.

Trouble-shooting

Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by

the electrical

motor within

the compressor

assembly; during

compressor start-up

the sound level will

be slightly higher for

a limited period of time.

∙ caused by the cooling agent ﬂ owing through the circuit.

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

p roblems, check ﬁ rst whether a solution can be found using

this table. If the problem persists, disconnect the appliance

from the mains power and contact our Customer Service

Department.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9954 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KS 9954 Manual

Product: