Manual Severin KS 9950 (page 18 of 40) (English, German, Dutch, French)

712696

Zoom out

Zoom in

1/40

out food.

∙ Frequent de-frosting helps to save energy. For detailed

information on cleaning the appliance, please refer to the

section De-frosting and cleaning.

∙ Do not set a lower-than-necessary temperature. For detailed

information on the temperature settings, please refer to the

section Temperature control.

Trouble-shooting

Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by the electrical

motor within the

compressor assembly;

during compressor

start-up the sound level

will be slightly higher for

a limited period of time.

∙ caused by the cooling

agent ﬂ owing through the circuit.

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

p roblems, check ﬁ rst whether a solution can be found using this

table. If the problem persists, disconnect the appliance from the

mains power and contact our Customer Service Department.

Transporting the appliance

To prevent damage to the unit during transport, ensure that all

accessories and components inside and around the appliance

are securely fastened.

The unit must only be transported in its vertical position; do not

tilt any more than 30°.

Once the unit has been positioned, wait for about 30 minutes

before it is connected to the mains.

If the unit has been tilted more than 30° during transport, allow

it to stand in an upright position for at least 4 hours before it is

connected to the mains.

Disposal

This appliance has been manufactured from

recyclable materials. After removing the plug from the

wall socket, the unit should be rendered unusable by

cutting off the power cord before disposing of it

through special waste collection points in accordance with local

regulations. The refrigerant and the chemical agent in the

insulation foam must be disposed of through a competent

agency. Take special care not to damage the cooling circuit

before the unit is handed over for such disposal.

Problem Possible cause and solution

The appliance is not working at all.

∙ There is a power failure

∙ The main fuse has blown.

∙ The temperature control is set to ‘0‘.

∙ The fuse in the wall socket (if applicable) has blown. This can be checked by

connecting another electrical device to the socket and checking for function.

The temperature inside the freezer

compartment is not low enough.

∙ Too much food has been stored in the appliance.

∙ The doors are not properly closed.

∙ There is too much dust on the condenser.

∙ Insufﬁ cient ventilation: the unit is too close to a wall or other structure or object.

∙ The temperature control is set too low.

The normal operating sound changes or

becomes louder.

∙ Check for proper positioning (uneven ﬂ oor?).

∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing

them to vibrate?)

∙ Are there any objects on top of the unit which might be vibrating?

Water is collecting on the bottom of the unit.

The melt-water drain system is blocked. Remove the blockage and clean the

system.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9950 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KS 9950 Manual

Product: