712701
18
Zoom out
Zoom in
Previous page
1/40
Next page
18
out food.
Frequent de-frosting helps to save energy. For detailed
information on cleaning the appliance, please refer to the
section De-frosting and cleaning.
Do not set a lower-than-necessary temperature. For detailed
information on the temperature settings, please refer to the
section Temperature control.
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
caused by the electrical
motor within the
compressor assembly;
during compressor
start-up the sound level
will be slightly higher for
a limited period of time.
caused by the cooling
agent owing through the circuit.
The following table lists possible malfunctions and their
probable causes and solutions. In the event of operational
p roblems, check rst whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the
mains power and contact our Customer Service Department.
Transporting the appliance
To prevent damage to the unit during transport, ensure that all
accessories and components inside and around the appliance
are securely fastened.
The unit must only be transported in its vertical position; do not
tilt any more than 30°.
Once the unit has been positioned, wait for about 30 minutes
before it is connected to the mains.
If the unit has been tilted more than 30° during transport, allow
it to stand in an upright position for at least 4 hours before it is
connected to the mains.
Disposal
This appliance has been manufactured from
recyclable materials. After removing the plug from the
wall socket, the unit should be rendered unusable by
cutting off the power cord before disposing of it
through special waste collection points in accordance with local
regulations. The refrigerant and the chemical agent in the
insulation foam must be disposed of through a competent
agency. Take special care not to damage the cooling circuit
before the unit is handed over for such disposal.
Problem Possible cause and solution
The appliance is not working at all.
There is a power failure
The main fuse has blown.
The temperature control is set to ‘0‘.
The fuse in the wall socket (if applicable) has blown. This can be checked by
connecting another electrical device to the socket and checking for function.
The temperature inside the freezer
compartment is not low enough.
Too much food has been stored in the appliance.
The doors are not properly closed.
There is too much dust on the condenser.
Insuf cient ventilation: the unit is too close to a wall or other structure or object.
The temperature control is set too low.
The normal operating sound changes or
becomes louder.
Check for proper positioning (uneven oor?).
Are any adjacent objects affected by the running of the cooling unit (i.e. causing
them to vibrate?)
Are there any objects on top of the unit which might be vibrating?
Water is collecting on the bottom of the unit.
The melt-water drain system is blocked. Remove the blockage and clean the
system.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9903 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9903 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info