347195

Severin ks 9886 Manual

12
Zoom out
Zoom in
Previous page
1/88
Next page
The temperature in the cabinet can be adjusted by setting the temperature
control. Turning the control clockwise will decrease the temperature, while
turning it anti-clockwise will increase it.
After switching on, the temperature control should be set to position 5. After
approx. 20 minutes, the setting should be changed to position 3. This setting is
usually sufficient for normal use.
Following a power interruption, or if the unit has been switched off on purpose, always wait
3 to 5 minutes before switching on again. The unit cannot be re-activated without this delay.
Storing wine
-
The temperature in the cabinet largely depends on factors such as the ambient
temperature, the setting and the number of wine bottles stored.
-
Turn the temperature control to the desired position.
-
Always ensure that the door is properly closed and that the seal is not obstructed by
bottles stored inside the cabinet.
De-frosting and cleaning
The integral evaporator is sealed in foam within the walls; you may therefore notice a build-
up of frost around the rear area. This layer of frost will start melting when the compressor is
not working. Through a system of hoses, the melt-water drains into the collection tray below
the compressor, where it will be absorbed into the surrounding air. The unit does not
therefore require de-frosting, but only proper cleaning.
● To enable the melt-water to drain freely, always ensure that the channel and discharge
opening in the cabinet are free of any blockage.
Cleaning the unit / periods of non-use
-
remove the plug from the wall socket
-
remove the bottles from the cabinet
-
leave the door open
To prevent any unpleasant odour within the cabinet, it should be cleaned at least every two
months. The surfaces and the drain channel may be cleaned with warm water. If necessary, a
mild detergent can be used. Wipe thoroughly dry and air out afterwards.
Take care not to remove or damage the rating plate inside the cabinet during cleaning.
Any dust deposits around the ventilation slots on the outside of the unit should be regularly
removed using a suitable brush or a vacuum cleaner. The build-up of dust will otherwise
cause an increase in energy consumption.
Remark: Do not use abrasive tools, materials containing alcohol or harsh cleaning solutions.
Do not use any electrical appliances, such as steam cleaners, for de-frosting or cleaning.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are
caused by:
-
the electric motor within the compressor assembly; during
compressor start-up the sound level will be slightly higher for
a short time.
-
the cooling agent flowing through the circuit.
The following table lists possible malfunctions, their probable causes and solutions. In the
12
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin ks 9886 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin ks 9886 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info