712734
13
Zoom out
Zoom in
Previous page
1/56
Next page
Installation
The appliance should be set up in a well-ventilated, dry room. It should be operated in an
ambient temperature of 16 to 32 °C and a relative humidity of max. 70 %. Do not expose the
appliance to direct sunlight, and do not position it next to any heat sources (radiators,
cookers etc). If this cannot be avoided, however, a suitable insulation must be installed
between the heat source and the unit.
To ensure sufficient air circulation, maintain a minimum distance of 50 mm between the
rear of the unit and the wall.
If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure
optimum stability. The whole unit should be installed at a slight angle in such a way that it
leans to the rear: this will ensure that the door closes automatically. However, both front
feet must be set to the same height.
Ventilation
The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure
that the air circulation behind the unit is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to
become left-hinged.
-
Take out the two screws (1) to remove the lower hinge (2).
-
Take off the door carefully.
-
Unscrew and remove the adjustable foot (4).
-
Remove the hinge pin (6) and spring (5).
-
Remove the blind covers (7) from the left mounting hole and fit it in the corresponding
place on the right.
-
Fit the spring (5) and hinge pin (6) into the left mounting hole (picture II).
-
Re-fit the adjustable foot (4) on the right-hand side.
-
Replace the door. Ensure that the hinge pin (6) sits properly in its corresponding guide
bushing.
-
Hold the door in position and insert the lower hinge (2) in the left-hand side. Secure the
hinge with the two screws (1).
Controls and interior light
Before the unit is connected to the mains power after installation, it should be left
standing in position for about 24 hours.
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9883 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9883 in the language / languages: English, German, Dutch, French, Swedish, Spanish as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info