712729
14
Zoom out
Zoom in
Previous page
1/112
Next page
14
Before using for the rst time
Remove any exterior and interior packaging materials
completely, including the red transport securing devices.
The packaging materials must be properly disposed of.
NOTE: When the door to the freezer unit is opened, a small
red component will fall out; this is for transport only and can
be disposed of.
Fit the two spacer
elements (provided) into
the corresponding guide
slots on the rear.
Before it is connected to
the mains, the unit must
be thoroughly checked for
transport damage, including its power cord.
Clean the unit as described in the section De-frosting and
cleaning.
For positioning, we recommend that you tilt the unit slightly
backwards. In this way, the transport rollers can be used to
move it to its intended place of installation.
The unit should only be transported in its vertical position;
do not tilt any more than 30°.
Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
When the unit is rst switched on, a slight ‘new’ smell may
be noticed. However, this will disappear once the cooling
process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room.
It should be operated in conditions where the relative
humidity is no more than 70 %.
The product data sheet contains details of the ambient
temperature range suitable for this appliance.
Do not use the appliance outdoors.
Ensure that the plug is accessible and can be removed from
the wall socket at any time.
Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc). If
this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
In the case of uneven oors, the adjustable feet on the unit
can be used to compensate and ensure optimum stability.
If the unit is installed next to a wall, a minimum lateral
distance of 225 mm is necessary, so that the doors can open
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9876 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9876 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info