Manual Severin KS 9837 (page 12 of 92) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish)

712714

Zoom out

Zoom in

1/92

Familiarisation

1. Temperature control (at the rear)

2. Vapouriser with storage rack

3. Adjustable front feet

4. Door

Before using for the ﬁ rst time

∙ Remove any exterior and interior packaging materials

completely, including the adhesive strips.

∙ Before it is connected to the mains, the unit must be

thoroughly checked for transport damage, including its

power cord.

∙ Clean the unit according to the instructions given in the

De-frosting and cleaning section below.

∙ The unit should only be transported in its vertical position;

do not tilt any more than 30°.

∙ Once the unit has been positioned, wait for about 30

minutes before it is connected to the mains.

∙ If the unit has been tilted more than 30° during transport,

allow it to stand upright for at least 4 hours before it is

connected to the mains.

∙ When the unit is ﬁ rst switched on, a slight smell may be

noticed. However, this will disappear once the cooling

process has begun.

Installation

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ It should be operated in conditions where the relative

humidity is no more than 70 %.

∙ The product data sheet at the end of this manual contains

details of the ambient temperature range suitable for this

appliance.

∙ Do not use the appliance outdoors.

∙ Ensure that the plug is accessible and can be removed

from the wall socket at any time.

∙ Do not expose the appliance to direct sunlight, and

do not position it next to any heat sources (radiators,

cookers etc.). If this cannot be avoided, however, suitable

insulation must be in installed between the heat source

and the unit.

∙ The unit must not be installed inside a cabinet, nor

directly below a hanging cupboard, shelf or similar object.

∙ In the case of uneven ﬂ oors, the adjustable foot on the

unit can be used to compensate and ensure optimum

stability.

Ventilation

Ensur e that there is enough space around the unit so that

the air circulation round and behind it is not obstructed.

(Rear 7.5 cm, sides 5 cm, top 10 cm.)

Reversible door

If required, the door may be reversed, i.e. from right-hinged

(default installation) to left-hinged.

Warning: Always disconnect the unit from the mains before

any maintenance or repair work is carried out.

1. Remove the hinge cover (1).

2. Use a suitable pointed tool to remove the cover (5).

3. Use a suitable screw-driver to remove the two screws

(2) holding the upper hinge (3) to the housing.

4. Carefully lift up the door and place it on a soft surface

to protect it from scratches.

5. Remove the blind covers for the hinge mounting holes

(9) and ﬁ t it in the corresponding place on the right.

Ensure that the cover is ﬁ rmly pushed down into the

hole.

6. Pull out the two screws (7) which hold the lower right

hinge plate (4) and the adjustable foot (6) in position.

Take off the hinge plate (4) and the adjustable foot (6)

and replace and tighten the two screws again.

7. Remove the adjustable foot (8) on the left and insert it

into the corresponding thread on the right.

8. Unscrew the two screws on the left-hand side and

install the lower hinge plate (4) with the two screws (7)

on this side. Caution: Do not yet tighten the screws.

9. Replace the door in its new position. Ensure that the

hinge pin is inserted into the guide bushing (hole) on

the lower part of the door.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9837 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KS 9837 Manual

Product: