603076
18
Zoom out
Zoom in
Previous page
1/112
Next page
18
absorbed into the surrounding air. The refrigerator cabinet
does not therefore require de-frosting, but only proper cleaning
instead.
To enable the melt-water to drain freely, always ensure that
the channel and discharge opening in the cabinet are free of
any blockage.
Energy saving tips
The appliance should be set up in a well-ventilated, dry
room.
Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc.).
If this cannot be avoided, however, suitable insulation must be
installed between the heat source and the unit.
Ensure suf cient air circulation around the unit.
The compressor (at the rear) should be cleaned at regular
intervals. Accumulated dust causes an increase in energy
consumption.
Warm food should be allowed to cool down before it is
stored inside.
To prevent an increased build-up of ice, do not leave the
doors of the unit open for too long when loading or taking
out food.
Frequent de-frosting helps to save energy. For detailed
information on cleaning the appliance, please refer to the
section De-frosting and cleaning.
Do not set a lower-than-necessary temperature. For detailed
information on the temperature settings, please refer to the
section Temperature control.
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
caused by the
electrical motor within
the compressor
assembly; during
compressor start-up
the sound level will be
slightly higher for a
limited period of time.
caused by the cooling agent owing through the circuit.
The following table lists possible malfunctions and their
probable causes and solutions. In the event of operational
p roblems, check rst whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the
mains power and contact our Customer Service Department.
Problem Possible cause and solution
The appliance is not working at all.
There is a power failure
The main fuse has blown.
The temperature control is set to ‘0‘.
The fuse in the wall socket (if applicable) has blown. This can be checked by
connecting another electrical device to the socket and checking for function.
The temperature inside the freezer
compartment is not low enough.
Too much food has been stored in the appliance.
The doors are not properly closed.
There is too much dust on the condenser.
Insuf cient ventilation: the unit is too close to a wall or other structure or object.
The temperature control is set too low.
The normal operating sound changes or
becomes louder.
Check for proper positioning (uneven oor?).
Are any adjacent objects affected by the running of the cooling unit (i.e. causing
them to vibrate?)
Are there any objects on top of the unit which might be vibrating?
Water is collecting on the bottom of the unit.
The melt-water drain system is blocked. Remove the blockage and clean the
system.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9783 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9783 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info