Manual Severin KS 9705 (page 16 of 124) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish)

712684

Zoom out

Zoom in

1/124

Before using for the ﬁ rst time

∙ Remove any exterior and interior packaging materials

completely, including the red transport securing devices.

∙ The packaging materials must be properly disposed of.

∙ NOTE: When the door to the freezer unit is opened, a small

red component will fall out; this is for transport only and can

be disposed of.

∙ Fit the two spacer elements (1, provided) into the

corresponding guide slots (2) on the rear.

∙ Before it is connected to the mains, the unit must be

thoroughly checked for transport damage, including its

power cord.

∙ Clean the unit as described in the section De-frosting and

cleaning.

∙ When the unit is ﬁ rst switched on, a slight ‘new’ smell may

be noticed. However, this will disappear once the cooling

process has begun.

Installation

∙ The appliance should be set up in a well-ventilated, dry room.

∙ It should be operated in conditions where the relative

humidity is no more than 70 %.

∙ Refrigeration appliances are classiﬁ ed into certain

climate classes. This classiﬁ cation indicates the ambient

temperature at which the device can be operated. Please

refer to the product data sheet for information on the

classiﬁ cation for this unit; the data sheet can be found at the

end of this manual.

∙ Do not use the appliance outdoors.

∙ Ensure that the plug is accessible and can be removed from

the wall socket at any time.

∙ Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers etc). If

this cannot be avoided, however, suitable insulation must be in

installed between the heat source and the unit.

∙ The unit must not be installed inside a cabinet, nor directly

below a hanging cupboard, shelf or similar object.

∙ In the case of uneven ﬂ oors, the adjustable front feet on the

unit can be used to compensate and ensure optimum stability.

∙ If the unit is installed next to a wall, a minimum lateral

distance of 225 mm is necessary, so that the doors can open

wide enough for the drawers to be taken out.

Set-up dimensions

Ventilation

Ensure that there is enough space around the unit so that the

air circulation round and behind it is not obstructed. (Rear,

sides and top 100 mm.)

Temperature control

∙ The unit is re-activated by connecting it to the mains. It

is only switched off completely when the plug is removed

from the wall socket. In position ‘0’, the cooling function is

switched off, though the appliance is still connected to the

mains.

∙ The temperature in the refrigerator cabinet can be adjusted

by setting the temperature control. Turning the control

clockwise will decrease the temperature, while turning it anti-

clockwise will increase it.

∙ The medium settings are usually most suitable for home

use.

∙ We recommend using a thermometer to check the actual

temperature inside the cabinet and make adjustments as

necessary.

∙ Following a power interruption, or if the unit has been

switched off on purpose, it may take around 5 minutes

before it switches on again.

Interior lighting

Caution: Do not remove the cover of the interior LED light. If

there should be any malfunction, please contact the customer

service for assistance.

Storing and freezing food

The temperatures inside the refrigerator cabinet and freezer

compartment depend mainly on the ambient temperature, the

temperature control setting and the amount of food stored. It

should also be noted that the interior temperature may increase

every time the door is opened.

Main cabinet

∙ Different areas of the refrigerator cabinet are affected

differently by the cooling effect. The warmest area is around

the door in the higher part of the cabinet, the coldest around

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9705 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KS 9705 Manual

Product: