712680
18
Zoom out
Zoom in
Previous page
1/124
Next page
18
Take care not to remove or damage the rating plate inside
the cabinet during cleaning.
De-frosting the freezer compartment
After a certain period of operation and depending on several
factors (e.g. how often the door has been opened), a layer
of ice will form on the evaporators located below the drawers
and on the drawer fronts themselves. Once the build-up
of ice has reached a thickness of 3 to 5 mm, the unit must
be de-frosted, as the build-up of ice increases the power
consumption of the appliance.
The freezer should be thoroughly cleaned at least twice a
year.
Always remove the plug from the wall socket before
cleaning.
Remove all food from the compartment and store it in a
cool location, eg together with pre-frozen freezer-packs
in a closed plastic container. Note that, even with a slight
increase in temperature, the storage life will be shortened
and the food should be used as soon as possible.
Keep the door open.
Remove the cover panel.
Pull out the drain channel from the freezer cabinet, turn it
180° and secure it (see diagram). Place a suitable container
underneath the channel outlet.
To accelerate defrosting, one or several containers with
hot (but not boiling) water may be placed inside the freezer
compartment. Do not pour water over or inside the unit.
Warning: Do not use any external device or other means
(e.g. heaters or heating fans) to accelerate de-frosting.
Clean the unit with a damp cloth and a little detergent. Wipe
thoroughly dry afterwards.
Replace the drain channel and cover panel.
Set the temperature control to its maximum position. After 24
hours, it may turned back to its normal setting.
Defrosting the refrigerator cabinet :
The refrigerator cabinet does not require de-frosting, but
only proper cleaning.
The integral vapouriser is sealed in foam in the rear wall;
you may therefore notice a build-up of frost around the
rear area. This layer of frost will start melting when the
compressor is not working. Through a system of hoses,
the melt-water drains into the collection tray below the
compressor, where it will be absorbed into the surrounding
air.
To enable the melt-water to drain freely, always ensure that
the channel and discharge opening in the cabinet are free of
any blockage.
Any water collecting in the bottom should be removed.
Energy saving tips
The appliance should be set up in a well-ventilated, dry
room.
Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc.).
If this cannot be avoided, however, suitable insulation must be
installed between the heat source and the unit.
Ensure suf cient air circulation around the sides of the unit.
The compressor (at the rear) should be cleaned at regular
intervals. Accumulated dust causes an increase in energy
consumption.
Warm food should be
allowed to cool down
before it is stored inside.
To prevent an increased
build-up of ice, do not
leave the doors of the
unit open for too long
when loading or taking out food.
Frequent de-frosting helps to save energy. For detailed
information on cleaning the appliance, please refer to the
section De-frosting and cleaning.
Do not set a lower-than-necessary temperature. For detailed
information on the temperature settings, please refer to the
section Temperature control.
Operating noise
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
caused by the electrical motor within the compressor
assembly; during compressor start-up the sound level will
be slightly higher for a limited period of time.
caused by the cooling agent owing through the circuit.
Trouble-shooting
The following table lists possible malfunctions and their
probable causes and solutions. In the event of operational
p roblems, check rst whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the
mains power and contact our Customer Service Department.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9701 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9701 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info