Manual Severin KM 3921 Mr. Twister (page 12 of 66) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish)

668415

Zoom out

Zoom in

1/66

In case of a defective appliance

A defective appliance can cause material

damage and injury

∙ Check the appliance and blade inserts

for damage before every use. Do not

operate if the appliance or a blade

insert shows any sign of damage.

∙ In the event that you detect damage,

please contact our customer service

department by phone or email (see

appendix).

∙ Repairs to this appliance or its power

cord must only be carried out by our

customer service.

Overview and parts included

1. Pestle (also holds food in position)

2. Feeder tube

3. Feeder tube with pestle

4. On/Off switch

5. Housing

6. Rating label (on underside)

7. Power cord with plug

8. Container

9. Cleaning brush

10. Gear-wheel insert

11. Blade insert - ‘Spaghetti’

12. Blade insert - ‘Tagliatelle’

Short-time operation

The appliance is designed for short-term operation only,

i.e. it should not be operated continuously for more than 10

minutes. Allow it to cool down for another 30 minutes, after

which it may be used again.

Blade inserts

This appliance comes with two different blade inserts:

‘

Spaghetti’ for 5 mm spirals

‘Tagliatelle’ for 9 mm spirals

To achieve optimum results, we recommend replacing the

blade inserts as soon as they start producing uneven or

unsightly spirals.

Cable storage compartment

There is a cable storage compartment at the rear of the

appliance. Pull out the cord to the required length before

use.

Operation

∙ Caution: Please take careful note of the diagrams at the

beginning of the manual before operating the appliance.

∙ Clean the food and cut it into pieces no longer than 15

cm.

∙ Hint: Always cut the food in such a way that

there is a ﬂ at surface to attach to the pestle

food holder.

∙ Place the container under the feeder chute.

∙ Fit the gear-wheel insert into the housing.

∙ Select the desired blade insert and ﬁ t it into the gear-

wheel insert.

∙ Fit the feeder chute and turn clockwise until it is heard

locking into place ( ).

∙ Take a prepared food item and attach its ﬂ at surface to

the end of the pestle (diagrams I & II).

∙ Insert the pestle with the food into the feeder chute.

Always hold the food ﬁ rmly in place until it actually

touches the blade insert (diagram III).

∙ Turn the appliance on and guide the pestle slowly

downwards, without applying ﬁ rm pressure (diagram

IV).

∙ Hint: Should a piece of food become separated

from the pestle, switch the appliance off and

disconnect it from the mains. Then take off the

feeder chute, remove the detached food and re-

attach it to the pestle.

∙ The processed food is collected inside the container.

∙ Take out the pestle and attach a new piece of food, if

desired.

∙ For technical reasons, a small piece if food will remain on

the pestle. Remove this and use it another time.

∙ Switch the appliance off and disconnect it from the mains.

After use

∙ The appliance should be thoroughly cleaned after each

use (see Cleaning and care).

∙ Empty the container.

∙ Take out the pestle.

∙ Remove the feeder chute by turning anti-clockwise (

∙ Remove the blade and gear-wheel inserts.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KM 3921 Mr. Twister in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,01 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KM 3921 Mr. Twister Manual

Product: