761526
28
Zoom out
Zoom in
Previous page
1/68
Next page
- 28 -
Step 1
a) Unscrew the cover of the door hinges and
remove it.
b) Unplug the cable. Unscrew the 4 screws
that hold the upper hinge and remove it.
Take off the loop on the ground cable of the
hinge. Insert the cable connection in the
opening on the top of the appliance. Take
off the door jack and the cover of the small
end caps.
Tips for Energy Saving
For the installation of the appliance, choose
a cool, dry and well-aired room.
Protect the appliance from direct insolation.
It should not be installed near heat sources
(stove, heater etc.). If this cannot be avoid-
ed, some sort of isolation between heat
source and appliance has to be used.
Don’t cover the ventilation openings and
grid. Provide enough circulation of air on
the backside of the appliance.
Let warm food cool down before you store
it in the fridge.
Do not leave the door open too long when
withdrawing or putting food inside. Other-
wise, the formation of ice in the interior will
be accelerated.
Do not set the temperature lower than
necessary. More details on temperature
settings can be taken from the chapter
‘Controls and Display’.
Operation Noises
There might be some typical operation noises
when the appliance is turned on. These are:
Noise of the electric
motor is arising from
the working compressor.
When the compressor
starts to operate, then
the noises get slightly
louder for a short time.
Noises in the tubes of the circulation of the
refrigerant.
Change the Door Stop
If necessary, the door can be changed from
right- to left-hinged.
Warning! Before you work on the appli-
ance, always pull the mains plug out of
the point.
In order to avoid damages to persons and
property, execute the change of the door
stop with two persons.
We recommend leaving the change of the
door stop to experts.
Before you start with the modications,
here is some general info:
ūAlways pay attention to the number of
shims on the bearing pins and screws.
ūPosition the doors always so that they
close tightly.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KGK 8943 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KGK 8943 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info