Manual Severin KB 8875 (page 14 of 32) (English, German, Dutch, French)

748173

Zoom out

Zoom in

1/32

De-frosting and cleaning

∙ Always remove the plug from the wall socket before

cleaning.

∙ When the build-up of ice has reached a thickness of

2 mm, the unit must be de-frosted.

∙ Turn the temperature control down to ‘0’ and leave the

door open.

Place the drip tray in the rear centre of the storage shelf.

The unit is now defrosting, and the resulting melt-water

is collected at the bottom and in the drip tray.

∙ Warning: Do not use any external device or other

means (e.g. heaters or heating fans) to accelerate de-

frosting.

∙ Do not pour water over or inside the unit.

∙ For frequent cleaning we recommend the use of

warm water with some mild detergent. To prevent any

unpleasant odour within the refrigerator, it should be

cleaned about once a month.

∙ Any accessories should be cleaned separately with

soapy water. Do not put them in a dishwasher.

∙ Do not use abrasives or harsh cleaning solutions or any

cleaning agents that contain alcohol.

∙ After cleaning, thoroughly clean all surfaces with fresh

water before wiping them completely dry. When re-

inserting the plug into the wall socket ensure that you

have dry hands.

∙ Take care not to remove or damage the rating plate

inside the cabinet during cleaning.

∙ To save energy, the compressor (at the rear) should be

cleaned carefully at least twice a year with a brush or a

vacuum cleaner.

Energy saving tips

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ Do not expose the appliance to direct sunlight, and

do not position it next to any heat sources (radiators,

cookers etc). If this cannot be avoided, however,

suitable insulation must be installed between the heat

source and the unit.

∙ Do not cover the ventilation openings and grilles, and

ensure sufcient air circulation behind the unit.

∙ The compressor (at the rear) should be cleaned at

regular intervals. Accumulated dust causes an increase

in energy consumption.

∙ Warm food should be allowed to cool down before it is

stored inside.

∙ Do not leave the fridge door open for too long when

loading or taking out food.

∙ Do not set a lower-than-necessary temperature. For

detailed information on the temperature settings, please

refer to the section Temperature control.

Trouble-shooting

Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by

the electrical

motor within

the compressor

assembly; during

compressor start-up

the sound level will

be slightly higher for

a limited period of time.

∙ caused by the cooling agent owing through the circuit.

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

problems, check rst whether a solution can be found using

this table. If the problem persists, disconnect the appliance

from the mains power and contact our Customer Service

Department.

Problem Possible cause and solution

The appliance is not working

at all.

∙ There is a power failure

∙ The main fuse has blown.

∙ The temperature control is set to ‘0‘.

∙ The fuse in the wall socket (if applicable) has blown. This can be checked by connecting

another electrical device to the socket and checking for function.

The normal operating sound

changes or becomes louder.

∙ Check for proper positioning (uneven oor?).

∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing them to

vibrate?)

∙ Are there any objects on top of the unit which might be vibrating?

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KB 8875 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KB 8875 Manual

Product: