544461
15
Zoom out
Zoom in
Previous page
1/88
Next page
15
over the rim of the lter sieve.
Removing the used espresso pad:
After the brewing cycle is complete, wait
for approximately 30 seconds until the
operating pressure has been suf ciently
reduced.
Exercise caution when removing
the lter holder: it is hot and may still
contain some hot water. Pour out the
water carefully.
Allow the lter holder to cool down
suf ciently before tapping its side against
a vertical surface to loosen the pad
before removing it.
The cut-out on the lter holder makes
it easier to remove the lter sieve; use
the ngers to pull the sieve out from
above. Clean the lter holder and sieve
thoroughly.
Drip tray
During operation, any excess water or steam
is collected in the drip tray. The tray must
therefore be tted whenever the espresso
maker is switched on. Caution: the drainer
and tray become very hot during use.
Always empty the drip tray in good time to
prevent water spillage.
Do not remove the drip tray unless the
appliance has been switched off and has
had suf cient time to cool down.
Preparation
Espresso
Fill the container with water.
Insert the plug into a suitable wall outlet
and use the On/Off switch to turn the
appliance on. The main red indicator light
comes on.
Preheat the lter holder and the cup.
Remove the lter holder, ll with ground
espresso coffee or load a pad and re-
attach it.
Place the cup under the lter holder
outlet.
Wait until the green temperature indicator
shows a steady light and turn the rotary
control to position
.
The pre-brewing function starts, ie the
ground espresso is pre-moistened with
water to ensure that the maximum coffee
avour is released.
The actual brewing process starts after
a short while, and the espresso is now
delivered straight into the cup.
Once the cup is full, turn the rotary control
to its neutral position to switch the pump
off (position ).
Wait for approximately 30 seconds before
detaching the lter holder and removing
the espresso grounds.
The espresso maker is now ready for
another brewing cycle.
Cleaning and care
Before cleaning the espresso maker,
ensure it is disconnected from the power
supply and has cooled down completely.
To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
Do not use abrasives or harsh cleaning
solutions.
All removable parts may be cleaned with
warm, soapy water; these parts are not
dish-washer safe.
Empty the drip tray daily and clean the tray
and drainer with warm, soapy water.
The exterior housing may be wiped with a
dry or slightly damp, lint-free cloth.
The boiler outlet may be wiped with a
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KA 5993 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KA 5993 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info