712347
11
Zoom out
Zoom in
Previous page
1/80
Next page
11
Do not leave the appliance unattended
while it is switched on.
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Cable storage compartment
There is a cable storage compartment at the
rear of the appliance. Pull out the cord to the
required length before use.
Automatic switch-off
To save energy, models with a thermo jug
will switch off automatically once the brewing
cycle has been completed.
Before using for the rst time
Before making coffee for the rst time, let the
appliance go through two or three ltration
cycles, using the indicated maximum amount
of cold water but without any coffee. This
procedure should also be gone through
if the appliance has not been used for an
extended time, and after descaling.
General information
The markings on the water reservoir help
you to measure the amount of water
needed to prepare the required number of
cups of coffee. The scale on the left-hand
side corresponds to medium-sized cups
with a capacity of approx. 125 ml; the
one on the right to smaller-sized cups.
Take care not to exceed the indicated
maximum number of cups. Take care not
to exceed the indicated maximum number
of cups.
If several consecutive brewing cycles
are required, switch off the machine after
each cycle and let it cool down for approx.
5 minutes.
Warning! Be careful not to put water into
the reservoir immediately after a brewing
cycle, as hot steam may escape from the
water nozzle.
To prepare lter coffee
Filling the water reservoir:
Open the water reservoir lid. Fill the reservoir
with the required amount of fresh cold water
and close the lid.
Inserting the paper lter:
Place a paper lter size 1x4 into the lter
holder, rst folding down its perforated sides.
Adding ground coffee:
We recommend using nely ground lter
coffee, approximately 6 g = 1½ - 2 tsp. per
medium-sized cup (125 ml).
Preparing the jug:
Place the aroma-protection lid onto the jug.
If correctly tted, the lid will disable the drip-
stop mechanism in the lter holder during the
brewing cycle.
Replace the jug in the appliance.
Starting the ltering process:
Insert the plug into a suitable wall outlet and
use the On/Off button to switch the coffee
maker on. The ltering process begins.
Removing the jug:
When the ltering process is complete, i.e.
all water has run through the lter into the
jug, remove the jug to serve the coffee.
The ma chine will switch off automatically
once the brewing cycle is complete.
Interrupting the brewing cycle:
To interrupt the brewing cycle, press the On/
Off button again to turn the appliance off.
Switching the coffee maker off:
Remove the plug from the wall socket once
brewing is complete.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KA 5827 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KA 5827 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info