● Do not place the appliance on any
surfaces sensitive to heat during or
immediately after use.
● This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
● Children should be supervised to ensure
that they do not play with the appliance.
● Caution: Keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is intended for domestic
use only and not for commercial
applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Before using for the first time
Clean the appliance and the heating plates
before use as described in the section
'General care and cleaning'.
Temperature selection
To prevent the hair from being damaged,
always start with a low temperature setting,
e.g. 120 - about 150°C for thin or sensitive
hair, 160 - about 190°C for thicker hair. If the
hair can be straightened at that setting in two
cycles, no further increase in temperature is
necessary, as the optimum setting has
already been reached.
Operation
-
The appliance should only be used on
dry or almost dry hair.
-
Insert the plug into a suitable wall outlet.
-
Use the On/Off switch to turn the
appliance on.
-
Use the temperature control to set the
desired level, observing the above
instructions. Pre-heating starts as shown
by the red indicator light.
● During the heating phase, the appliance
should be placed on a firm, heat-resistant
surface.
-
Once the desired temperature has been
reached, the indicator light changes to
green.
-
Take each strand of hair as close as
possible to the roots and place it between
the heating plates.
-
Bring the two arms together on the hair
and gently pull through the hair, starting
from the roots and working your way out
to the ends.
-
Open the arms.
-
Check whether the result is as desired.
-
If you wish the shaping to be more
pronounced, repeat the process, allowing
the heat to take effect slightly longer, or
dividing the hair into smaller strands.
-
Switch off after use, remove the plug
from the wall socket, place the appliance
on a heat-resistant surface and allow it to
cool down.
General care and cleaning
● Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
● To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
● Do not use abrasives or harsh cleaning
solutions.
-
The exterior of the appliance may be
wiped with a slightly damp, lint-free
cloth.
-
The heating plates may be cleaned with a
slightly damp cloth, using a mild
8
