712514
9
Zoom out
Zoom in
Previous page
1/46
Next page
GB
Hair straightener
Dear Customer,
Before using the appliance, the user must read
the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage corresponds
with the voltage marked on the rating label.
This product complies with all binding CE
labelling directives.
Familiarisation
1. Steam vents
2. Grip area
3. Locking mechanism
4. Power cord with flexible joint and hanging
loop
5. On/Off switch
6. Temperature control
7. Indicator light
8. Heating plates
Important safety instructions
Caution: do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin filled
with water or near any other receptacle
containing water.
Protect the appliance from moisture and
splashing water and do not operate it with
wet hands.
In the vicinity of any water source, there is
a risk even when the appliance is switched
off. Therefore, always remove the plug from
the wall socket after use, especially if the
appliance is being used in a bathroom.
Additional protection is available by fitting
an earth-leakage circuit-breaker with a rated
tripping current not exceeding 30mA into
your bathroom installation. Please consult a
qualified electrician.
The heating plates operate at very high
temperatures. Caution: skin contact with
these parts may cause burns. Do not touch
any part of the appliance except the grip
area.
As the heating plates operate at high
temperatures, contact with the hair should
be limited to a maximum of a few seconds
at a time.
Do not use the appliance on synthetic hair-
pieces or wigs, as the heat emitted might
cause damage to the synthetic fibres.
Before the appliance is used, the main
body as well as any attachments should be
checked thoroughly for any defects. If the
appliance, for instance, has been dropped
onto a hard surface, it must no longer be
used: even invisible damage may have
adverse effects on its operational safety.
The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
Do not operate the appliance if excessive
force has been used to pull the power cord.
Damage cannot always be detected from
the outside; the entire unit should therefore
be checked by a qualified technician before
it is used again.
To prevent damage to the power cord,
- do not bend or kink the cable, especially
where it leaves the housing,
- do not pull on the cord,
- do not coil the cord around the appliance.
Do not leave the appliance unattended
while in use.
Take special care not to let any hot parts of
the appliance come into contact with the
scalp, ears or face.
Caution: the hot or steam escaping from
the vents is extremely hot.
Do not allow the power cord to touch hot
surfaces.
Always remove the plug from the wall
socket
- after use,
9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin HC 0616 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin HC 0616 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info