Manual Severin GS 8858 (page 22 of 52) (English, German, Dutch, French)

761641

Zoom out

Zoom in

1/52

- 22 -

Making ice cubes

A special ice-cube tray is provided for making

ice cubes. Fill the tray up to ¾ with drinking

water and place it in the freezer compartment

for a few hours. The ice cubes are easier to

remove from the tray if the tray is left stand-

ing at room temperature for 5 minutes.

Cleaning and Defrosting (Maintenance)

Cleaning

• Always pull the mains plug before cleaning.

• Do not pour water into the appliance.

• Tepid water with a bit of washing-up liquid

is suitable for the regular maintenance.

• Clean the equipment separately with rins-

ing water, not in the dishwasher.

• Do not use aggressive, abrasive or alcoholic

detergents.

• After cleaning it with clear water, wipe the

surface and carefully dry it off. Subsequent-

ly, plug the mains plug with dry hands.

• In order to save energy and maintain the

efciency, you should clean the condenser

(on the backside) and the compressor at

least twice a year with a broom or vacuum

cleaner.

• The rating label in the interior of the appli-

ance cannot be damaged or even removed

while cleaning.

Defrosting

If the ice layer in the interior is 2-4 mm thick,

the appliance must be defrosted. Clean it at

least twice a year.

• Disconnect the mains plug from the socket.

• Remove food from the appliance and store

it as cool as possible, e.g., together with

ice packs and covered in a plastic recipi-

ent. Please remember that the lifetime of

the goods is shortened by the temperature

increase and that they should be consumed

as quickly as possible.

• Leave the door open. To speed up defrost-

ing, place one or more pots with hot but

not boiling water in the freezer.

• Warning! Do not use other mechanical

devices or any other means, e.g., heating

appliances, to speed up defrosting.

• Dry the appliance thoroughly after cleaning.

• Plug in the mains plug. Wait approx. 5

minutes and set the temperature controller

to the desired position.

Tips for Energy Saving

• For the installation of the appliance, choose

a cool, dry and well-aired room.

• Protect the appliance from direct insolation.

It should not be installed near heat sources

(stove, heater etc.). If this cannot be avoid-

ed, some sort of isolation between heat

source and appliance has to be used.

• Don’t cover the ventilation openings and

grid. Provide enough circulation of air on

the backside of the appliance.

• Let warm food cool down before you store

it in the fridge.

• Do not leave the door open too long when

withdrawing or putting food inside. Other-

wise, the formation of ice in the interior will

be accelerated.

• Do not set the temperature lower than

necessary. More details on temperature

settings can be taken from the chapter

‘Operating elements’.

Operation Noises

There might be some typical operation noises

when the appliance is turned on. These are:

• Noise of the electric

motor is arising from

the working compressor.

When the compressor

starts to operate, then

the noises get slightly

louder for a short time.

• Noises in the tubes of the circulation of the

refrigerant.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin GS 8858 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,13 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin GS 8858 Manual

Product: