668411
13
Zoom out
Zoom in
Previous page
1/76
Next page
13
Operation
Preparing the ingredients
Clean and cut up the fruit or vegetable as
necessary, so that the pieces t down the
feeder tube. Remove any stones, pips or
cores to prevent damage to the appliance.
Preparing the appliance
Ensure that the switch is set to its 0
position.
Place the lter holder onto the drive unit
with the juice outlet to the right.
Fit the lter into its holder, pushing it rmly
down by the rim until it is heard locking
into place. It is important that the lter is
securely attached and not at an angle,
and that it can be turned easily.
Slide the pulp container on the left side of
the unit under the rim of the lter holder,
tilting the container slightly.
Place the transparent lid onto the lter
holder. The left side of the lid must
engage in the pulp container. Secure the
lid with the locking clip, which will activate
the safety switch. Ensure that the locking
clip engages rmly on both sides into the
locking recesses on the lid.
Fit the juice container with its lid below the
outlet.
Juicing
Insert the plug into the wall outlet and put
the switch to the required setting.
Feed the clean, pre-cut fruit or vegetable
pieces down the feeder tube while the
unit is running. When inserting the pestle,
ensure that its guide slots slide over the
two protruding knobs on the feeder tube,
and then push the pieces lightly down.
Caution: Excessive pressure may result
in damage to motor or lter.
When processing large quantities of fruit
or vegetables, the pulp container and
juice container must be emptied from time
to time as necessary.
If larger quantities of food pulp should
have accumulated in the lter holder,
switch the appliance off, disconnect it
from the mains and clean out the lter
holder.
After use
After use, remove the juice container,
switch the appliance off and disconnect it
from the mains.
Make sure to clean the appliance
thoroughly after each cycle of use. For
detailed information, please refer to the
Cleaning and care section.
To detach the lter and lter holder,
remove the pulp container rst. Then
fold down the locking clip and take off the
pestle and lid.
Place your left hand under the lter
holder and your right hand under the juice
outlet. Pull the lter holder up by applying
pressure to left and right alternately, until
it comes clear.
Take off the lter holder and lter.
Juice container
With the lid left in place when pouring out
the juice, the foam caused during juice
extraction will remain inside the container.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin ES 3570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin ES 3570 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info