397524
8
Zoom out
Zoom in
Previous page
1/46
Next page
Useful information
-
To position it firmly, we recommend
pressing the appliance lightly down onto
the work surface before use; this will
ensure that the suction feet are firmly
attached to the surface.
-
This appliance allows natural, vitamin-
rich juices to be extracted from fruit and
vegetables.
-
To preserve the maximum vitamin
content, the juices are best drunk fresh, ie
immediately after extraction.
To store, place the fresh juice in the
refrigerator in a covered container.
-
It is advisable to use glass or plastic
containers, since metal containers might
affect the taste.
-
After cleaning, cut up the fruit or
vegetable so that it fits down the feeder
tube. Before extracting juice from fruit or
vegetables with stones, please remove
any stones to prevent damage to the
appliance; in addition, removing the
cores optimises the juice extraction.
-
The following fruits and vegetables are
not suitable for juice extraction: figs,
grapes, avocados, aubergines,
raspberries, blackberries, currants,
elderberries, rhubarb, blueberries,
cranberries, beetroot etc.
-
Tomatoes should be lightly carved in
with a knife before juice extraction.
-
Bananas should be added for aromatic
purposes only, as very little juice can be
extracted.
Short-time operation
The appliance has been designed for short-
term operation only, i.e. it should not be
operated continuously for more than 2
minutes at a time. Switch off the appliance
afterwards and allow the motor to cool
down before switching it on again.
Before using for the first time
-
Before the appliance is used for the first
time, it must be cleaned as described in
the section General Care and Cleaning.
Switch
The appliance is equipped with a 3-position
switch.
0 appliance switched off
1 slow juice extraction
2 fast juice extraction
We recommend starting extraction with the
slow setting and switching to the faster
setting only when necessary.
Operation
-
Place the pulp container onto the holding
platform on the side of the drive unit.
-
Fit the juice outlet insert onto the drive
unit.
-
Fit the filter and grating plate insert onto
the drive shaft coupling and push the
insert down until it is heard locking into
place. It is essential that the filter is
properly locked; otherwise, if it is not
correctly connected to the drive shaft,
damage may occur during operation.
-
Place the transparent lid onto the juice
outlet and use the two locking clamps to
lock the lid to the drive unit; this will
activate the safety switch. If the clamps
are not securely locked, the safety switch
will prevent the motor from operating.
-
Place the juice container directly
underneath the juice outlet.
-
Insert the plug into the wall outlet and set
the switch to the required setting.
-
Feed the cleaned and pre-cut fruit or
vegetable pieces down the feeder tube
while the unit is running. Use the pestle
and lightly push the pieces down.
Excessive pressure may result in damage
to the motor or grating plate!
-
When processing large quantities of fruit
or vegetables, the pulp container and
juice container must be emptied from
time to time as necessary.
-
After use, switch the appliance off and
remove the plug from the wall socket.
General Care and Cleaning
Always remove the plug from the wall
socket and allow the appliance to cool
8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin es 3561 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin es 3561 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info