Manual Sentiotec CV 31 (page 44 of 72) (English, German)

753056

Zoom out

Zoom in

1/72

Instructions for installation and use p. 10/34

The sauna control unit is installed outside the sauna cabin or according to the

recommendation of the cabin manufacturer. The electrical supply is a xed con-

nection. (Observe Fig. 1)

1. Gently press in lock 3 and remove housing cover 4.

2. Screw in cross-head screw for the upper mounting hole 1 until a distance

of 7 mm to the sauna wall (see detail).

3. Suspended housing lower part 2 in position 1 onto the mounted cross-

head screw.

4.2. Installing the heater sensor F1 with excess temperature fuse

Note Fig. 4 (gures chapter):

●The heater sensor must be installed on the rear of the heater, above the mid-

dle of the sauna heater. An interval of approx. 15 cm to the roof of the sauna

room must be maintained.

●The heater sensor must be attached in a way that it is not affected by

a ow of air.

1. Lay the two 2-pin heater sensor wires in the wall of the sauna room, leading

them to the heater sensor installation location and afx the heater sensor

wires using wire clips.

2. Pull the two half-shells 1 of the heater sensor apart.

3. Connect the four connectors for the heater sensor wire 5 in accordance

with Fig. 4.

4. Place the connection panel 2 crossways in the heater sensor half-shells.

5. Place the two half-shells together, screw them together using the two Phillips-

head screws 3 (9 mm) and check whether the heater sensor has been

securely closed.

6. Install the heater sensor on the rear of the heater using the two wood screws

enclosed 6 (16 mm).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sentiotec CV 31 in the language / languages: English, German as an attachment in your email.

The manual is 1,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sentiotec CV 31 Manual

Product: