690256
34
Zoom out
Zoom in
Previous page
1/41
Next page
If a problem occurs ...
34 | Flex 5000
Occasional
sound dropouts,
it might be that
you hear 5
beeps via the
receiver
The receiver is out of the
transmitter’s range.
Reduce the distance between the
receiver and the transmitter.
The signal is shielded.
Remove obstacles between the
transmitter and the receiver.
Observe the attachment
recommendations for your receiver.
20
There are interfering devices (e.g.
WiFi router, Bluetooth devices or
microwaves) in the vicinity.
Change the position of the transmitter
or of the receiver.
10
Separate the transmitter from other
wireless devices by at least 50 cm/
20”.
Sound too low
The volume on the receiver is
adjusted to low.
Increase the volume on the receiver. 21
The volume of the analog audio
source is adjusted to low.
Increase the volume of the analog
audio source to at least a medium
level (approx. 1 V
rms
).
The headphones are muted or the
headphone volume is adjusted too
low.
Check the settings of the headphones
used.
The headphones used have a too
high impedance/too low nominal
sound pressure level.
Use low-impedance headphones or
headphones with a high nominal
sound pressure level.
Sound only on
one ear
The balance is misadjusted. Adjust the balance. 22
The audio cable is not properly
connected.
Check the audio plug connection. 11
The TV has only a mono headphone
socket.
Use an adapter (mono to stereo jack
socket) to connect the transmitter to
the TV.
Sound is
distorted
The audio cable is defective. Replace the audio cable.
The signal of the audio source is
distorted.
Reduce the volume of the audio
source.
The volume on the receiver is
adjusted to high.
Reduce the volume on the receiver. 21
You hear echoes
when using the
stethoset
receiver with a
TV
You are using open headphones.
Use closed headphones or earphones/
ear canal phones.
Some TVs can adjust a delay or
latency of the audio signal for the
digital audio output.
Check the audio output settings of
your TV and set the latency to “0”.
The battery
status display
goes off
The battery status display is set so
that it goes off after 30 seconds.
Set the battery status display so that
it is permanently displayed.
29
More than one receiver is currently
connected to the transmitter.
This function is only possible when
only one stethoset receiver/receiver is
connected to the transmitter.
2 beeps during
operation
The rechargeable battery is almost
empty.
Recharge the rechargeable battery. 16
Problem Possible cause Possible solution Page
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sennheiser FLEX 5000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sennheiser FLEX 5000 in the language / languages: English as an attachment in your email.

The manual is 7,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sennheiser FLEX 5000

Sennheiser FLEX 5000 User Manual - German - 39 pages

Sennheiser FLEX 5000 User Manual - Dutch - 39 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info