575969
30
Zoom out
Zoom in
Previous page
1/37
Next page
If a problem occurs ...
29
If a problem occurs ...
EK 100 G3
Problem Possible cause Possible solution
Diversity receiver cannot
be operated, “Locked
appears on the display
panel
Lock mode is activated Deactivate the lock mode (see page 20).
No operation indication Batteries are flat or accupack is flat Replace the batteries or recharge the accupack
(see page 10).
No RF signal Transmitter and receiver are not on the
same channel
Set the transmitter and receiver to the same
channel.
Synchronize the transmitter with the receiver
(see page 19).
Transmission range is exceeded Reduce the distance between receiver and
transmitter.
RF signal is deactivated (“RF Mute“) Activate the RF signal (see page 21).
RF signal available, no
audio signal, “MUTE
appears on the display
panel
Transmitter is muted Cancel the muting (see page 21).
Receiver’s squelch threshold is adjusted
too high
Reduce the squelch threshold setting on the
receiver (see page 24).
Transmitter doesn’t transmit a pilot tone Deactivate the pilot tone evaluation
(see page 24).
Audio signal has a high
level of background noise
Transmitter sensitivity is adjusted too
low
Adjust the transmitter sensitivity correctly
(“Sensitivity”, see page 25).
Audio signal is distorted Transmitter sensitivity is adjusted too
high
Adjust the transmitter sensitivity correctly
(“Sensitivity”, see page 25).
Receiver’s audio output level is adjusted
too high
Reduce the audio output level (“AF Out”, see
page 24).
No access to a certain
channel
During scanning, an RF signal has been
detected on this channel and the channel
has been locked
Set the transmitter operating on this channel to
a different channel and redo the frequency
preset scan (see page 24).
During scanning, a transmitter of your
system operating on this channel has not
been switched off
Switch the transmitter off and redo the
frequency preset scan (see page 24).
ew 100 P G3 Set _529660_0309_Sp9.book Seite 29 Mittwoch, 8. April 2009 6:57 18
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sennheiser EW 100 G3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sennheiser EW 100 G3 in the language / languages: English as an attachment in your email.

The manual is 5,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info