759027
7
Zoom out
Zoom in
Previous page
1/8
Next page
Electric Kettle
SWK 1501GR / SWK 1502BL / SWK 1503OR / SWK 1504RD / SWK 1505VT / SWK 1506YL / SWK 1507TQ
EN
EN-7
2018 03/2018
BEFORE FIRST USE
1. Remove all wrapping material from the kettle and its base.
2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the contents of the kettle.
Repeat this process 2 to 3 times.
Note:
To boil water in the kettle proceed according to the instructions in chapter Using the kettle.
3. Now the kettle is ready for use and for preparing warm beverages, etc.
U SING THE KETTLE
1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place the base on
astable, even and clean surface.
2. Fill the kettle with the required amount of water. You may fill the kettle through the spout or through the opening
after lifting the lid. To open the lid, press the safety lid lock A2 in the direction of the handle. The water level must
reach at least the minimum mark (0.5l) and must not exceed the maximum mark (1.5l).
Warning!
Never fill the kettle if it is located on the base.
If the kettle is overfilled, then boiling water could splash out.
3. Place the kettle on the base. Insert the power plug into the an electrical power socket. Check that the lid of the
kettle is closed.
4. Start the kettle by moving the switch to position I(On). The power On light will illuminate.
Attention:
Do not turn on the kettle if it is empty. The incorrect use of the kettle may negatively affect its lifetime.
If you accidentally turn on the kettle without water, the thermostat will, after reaching acertain
temperature, interrupt the electric circuit and the power On light will turn off. The kettle can be used
again after several minutes, as soon as its stainless steel bottom has cooled down.
5. As soon as water boils the kettle will turn off automatically and the power On light will turn off. Before taking the
kettle off the base, check that it has turned itself off automatically. If it has not automatically turned itself off, turn
off the kettle manually by moving the switch to position 0 (Off).
Note:
The operation of the kettle can be interrupted at any time by moving the switch to position 0 (Off).
6. Pour the boiled water into aprepared container, cup or mug. Make sure that the kettle remains in ahorizontal
position when it is carried, particularly if it is filled all the way up the maximum mark. If you wish to open the lid to
refill the kettle, first empty all the contents from the kettle so that you are not scalded by the escaping steam.
7. After you finish using the kettle, disconnect the power cord from the el. power socket. Empty the kettle and allow
it to cool down.
CLEANING AND MAINTENANCE
Cleaning the filters
The removable filter serves to capture scale deposits and prevent them from getting into the prepared beverage.
Regularly clean the filter under running water using afine nylon brush or submerge it for several hours into avinegar-
water solution (recommended dilution ratio 1:2). After applying the solution rinse the filter under clean running water.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SWK 1506 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SWK 1506 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info