758414

Sencor SSV 230 Manual

6
Zoom out
Zoom in
Previous page
1/7
Next page
06/2017
- 6 - Copyright © 2017, Fast ČR, a.s.
EN Electric Spiralizer
User'smanual
■ Prior to using this appliance, please read the user’smanual thoroughly,
even if you already have experience in using similar appliances. Only
use the appliance in the manner described in this user’smanual. Keep
this user’s manual in asafe place where it can be easily retrieved for
future use.
■ We recommend saving the original cardboard box, packaging
material, purchase receipt and responsibility statement of the vendor
or warranty card for at least the duration of the legal liability for
unsatisfactory performance or quality. In the event of transportation,
we recommend that you pack the appliance in the original box from
the manufacturer.
DESCRIPTION OF THE APPLIANCE
A1 Button for releasing the
extension of the inner part of
the pusher
A2 Inner part of the pusher
A3 Pusher outer case cover
A4 Pusher outer case
A5 Lid with feed tube
A6 Blade holder with aperipheral
cog wheel
A7 Blade for cutting spaghetti
strips measuring 3 × 3 mm
A8 Blade for cutting spirals,
cutting thickness 3 mm
A9 Insertion hole for the blade
holder
A10 Jug lid
A11 1.7-litre transparent jug
A12 Drive unit
A13 0/Iswitch (o/on)
A14 Anti-slip feet
BEFORE FIRST USE
1. Take the appliance and its accessories out of the packaging materials.
2. Thoroughly wash all parts that are intended to come into contact with
food using warm water and aneutral kitchen detergent. Then rinse
under clean water and allow them to dry naturally or dry them using a
wiping cloth. Do not submerge the drive unit A12 in water or rinse it
under running water.
Attention:
Be especially careful when cleaning the blades A7 and A8 to
avoid injury on the sharp edges.
ASSEMBLING AND DISASSEMBLING THE APPLIANCE
■ Before you start assembling or disassembling the appliance, check
that it is turned o and disconnected from the power socket.
■ Place the drive unit A12 on an even, dry and stable surface. Place
the jug A11 under the insertion hole A9 so that the handle points
outwards and so that it is properly seated in its place (see g. C1).
Otherwise, the appliance will not start when turned on. The lid A10
serves to cover the jug A11 when it is not located in the drive unit
A12, for short term food storage.
■ Insert the blade A7 or A8 from above into the holder A6 and push
down the blade edges to that the blade ts in along the entire
perimeter of the holder A6 (see g. B1).
Attention:
When inserting blade A7 or A8 into the holder A6 take care not
to injure yourself on its sharp edges.
■ Insert the assembled holder with the blade from above into the
insertion hole A9 ensuring that the peripheral cog wheel on the
holder A6 slides into the cog wheel that is apart of the drive unit A12
(see g. C2). On to the drive unit A12 place the lid with the feed tube
A5 so that the arrow symbol marked on the lid A5 is aligned with the
open padlock symbol marked on the drive unit A12 (see g. C3). Turn
the lid A5 clockwise all the way to secure it in position. The arrow
symbol marked on the lid A5 is now aligned with the closed padlock
symbol on the drive unit A12. Unless the lid A5 is properly attached,
the appliance will not start when turned on.
■ Into the outer case A4 insert the inner part of the pusher A2, and to
connect these two parts press the cover A3 towards the outer case
A4 while at the same time turning it anticlockwise all the way. Insert
the pusher assembled in this way into the feed tube A5 (see g. C4).
Button A1 serves to release the extension of the inner part of the
pusher A2. When button A1 is pushed, the inner part of the pusher
A2 will extend out upwards. This will release the remaining foodstus
from the bottom part of the pusher when the appliance is used. Lock
the extension in place by pushing the inner part of the pusher A2
down into the outer case A4 until it is secured in place by both latches
on the inner part of the pusher A2 in the cover A3.
■ Disassemble the appliance in the reverse sequence. To remove the
blade A7 or A8 from the holder A6, it is rst necessary to push down
the latches of the blade A7 or A8 from underneath (see g. B2). This
will release the blades and it is then possible to remove them.
OPERATING THE APPLIANCE
1. This appliance is suitable for processing harder types of fruits and
vegetables such as, for example, carrot, apple, celery, zucchini,
cabbage, beetroot, pumpkin, cucumber, potatoes, sweet potato, etc.
in the raw form. It is not particularly suitable for processing soft types
of fruits and vegetables.
2. Thoroughly wash all the fruit and vegetables. Certain types may need to
be cut up to pass through the hole of the feed tube A5. This means that
the diameter of the fruit or vegetable should not be greater than 75 mm
and the length should be no greater than 175 mm. Kernels and stones
also need to be removed from certain types of fruit and vegetables.
Attention:
Never attempt to use this appliance to process hard stones
contained in, for example, mangoes, etc.
3. Make sure that the appliance is properly assembled and located on
an even, dry and stable surface. Connect the power plug to apower
socket and set the switch A13 to position I(on).
4. Start gradually inserting the fruit or vegetables into the hole of the
feed tube A5 and push them through the feed tube A5 with the
properly assembled pusher. To release any remaining foodstus from
the bottom part of the pusher, use button A1 as described in chapter
Assembling and disassembling the appliance.
Attention:
Do not use ngers or other items to push food in.
The maximum continuous operating time is 1 minute. Before
turning it on again, allow the appliance to cool down for at least
5 minutes.
5. In the event that the jug A11 lls up during operation, turn o the
appliance, disconnect it from the power socket and make sure that the
rotating parts have stopped. Empty the jug A11 and put it back in its
place. Then you can use the appliance again.
6. When you have nished using it, set the switch A13 to position 0
(o), disconnect the appliance from the power socket and clean it out
according to the instructions contained in the chapter Cleaning and
maintenance.
QUICK GUIDE TO PROCESSING FRUIT AND VEGETABLES
Type of fruit or
vegetable
Type of blade Maximum
amount per
batch
Approximate
operating
time
Carrot A7 or A8 500 g 30 s
Potatoes A7 or A8 500 g 30 s
Cucumber A7 or A8 500 g 30 s
Cabbage A7 500 g 30 s
Zucchini A7 or A8 500 g 30 s
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SSV 230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SSV 230 in the language / languages: English as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sencor SSV 230

Sencor SSV 230 User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info