758817

Sencor SSJ 5050 Manual

7
Zoom out
Zoom in
Previous page
1/10
Next page
Slow Juicer
SSJ 5050SS / SSJ 5051RD
EN
EN-7
04/2016
Copyright © 2016, Fast ČR, a.s.
USING THE JUICER
1. Make sure that the juicer is correctly assembled and that the control dial Aqs is set to the 0 position
(turned off). Then plug the juicer into a power socket.
2. Prepare the fruit or vegetables. Thoroughly wash the ingredients and cut them up into pieces
2 × 4.5 cm that will pass through the feed tube A2. Remove hard stones that are contained in, for
example, apricots, peaches, mangoes, etc. inedible peels, e.g. from oranges, pineapples, melons,
mandarins, etc. and hard peels, e.g. from potatoes, beetroot, etc.
3. Prior to starting the juicer, make sure that the lid A2 is properly secured using the locking arms
Aqa. Start the juicer by setting the control dial Aqs to position I (turned on). Take the pusher A1
out of the feed tube A2. Gradually add the prepared ingredients into the feed tube A2 and push
them down using the pusher A1. You will achieve optimal results if you fill the feed tube A2
gradually and push the ingredients down gently.
Attention:
Do not use fingers or other utensils to push ingredients through the feed tube A2. Always use
the pusher A1 designed for this purpose.
The maximum time of non-stop operation of this appliance is 10 minutes. Then allow it to cool
down for 10 minutes.
4. If the juice jug A0 or pulp container A9 fill up during the juicing process, turn the juicer off by
setting the control dial Aqs to position 0 (off), empty out the respective container and then put it
back in its place. Then you can put the juicer back into operation and continue juicing.
5. If the juice collector A6 becomes clogged, set the control dial Aqs to position "R" (reverse motor
rotation). Hold it in this position for 3 to 5 seconds and then release it. The control dial Aqs will
return to position 0 (off). Repeat the entire process two to three times. In the same way, we
recommend that you remove pulp remains from the juice collector A6 when you have finished
juicing.
Note:
In the event that the described procedure does not help, it is necessary to turn off the juicer,
disconnect it from the power socket, disassemble it and clean the individual parts.
6. After finishing juicing, turn the juicer off by setting the control dial Aqs to the 0 position (off) and
disconnect it from the power socket. We recommend that you only remove the juice jug A0 after
juice stops dripping from the spout A8.
7. After every use, disassemble the juicer, see chapter Disassembling the juicer and clean it out
according to the instructions contained in chapter Cleaning and maintenance.
USEFUL ADVICE AND TIPS
• Before you start juicing, thoroughly wash all the ingredients and cut them up into smaller pieces
measuring 2 × 4.5 cm that will pass through the feed tube A2. Remove hard stones that are
contained in, for example, apricots, peaches, mangoes, etc. inedible peels, e.g. from oranges,
pineapples, melons, mandarins, etc. and hard peels, e.g. from potatoes, beetroot, etc.
• To achieve optimal results, always process only fresh ripened fruits and vegetables. Overripe or
unripe fruits and vegetables will negatively affect the resulting taste of the juice.
• If you juice fruits and vegetables of varying consistency, we recommend that you start with the
softer fruits and vegetables, e.g. citruses, berries, etc. and then proceed on with harder fruits,
e.g. apples.
• We do not recommend juicing bananas because they have a very low juice content.
• Juice leafy vegetables together with other fruits and vegetables, e.g. apples, carrot, beetroot,
citruses, etc. pushing them into the feed tube A2 at the same time.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SSJ 5050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SSJ 5050 in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info