758815
6
Zoom out
Zoom in
Previous page
1/10
Next page
EN-6
EN
Juicer
SJE 1055SS / SJE 1056RD / SJE 1057BK
2016 02/2016
BEFORE FIRST USE
1. Remove all packaging materials from the appliance and its accessories.
2. Thoroughly wash all removable parts (pusher A1, lid A3, stainless steel strainer A4, juice collector
A5, the juice jug A0 and pulp container A6) that come into contact with food in warm water
using kitchen detergent. Then rinse all these parts under clean running water and thoroughly wipe
dry with a fine wiping cloth.
3. The pusher A1, stainless steel strainer A4 and the pulp container A6 may be washed in
a dishwasher. We recommend washing the stainless steel strainer A4 in the top rack of the
dishwasher.
Attention:
The blade at the bottom of the stainless steel strainer A4 is very sharp and so it is necessary to
be especially careful when handling it. Careless handling may lead to injury.
ASSEMBLING THE JUICER
1. Place the juicer on an even, dry surface, e.g. on a work table. Prior to assembly, always check that
the juicer is turned off (control dial is in position 0 – turned off) and the power cord is disconnected
from the power source.
2. Insert the juice collector A5 into the juicer base unit A9 as shown in the picture. Make sure that
the juice collector spout A7 is located in the groove in the base unit.
3. Insert the stainless steel strainer A4 into the juice collector A5. Make sure that the strainer is
properly seated on the drive shaft.
4. Tilt the pulp container A6 with its upper edge towards the base unit A9 and slide it from
underneath on to the rim of the juice collector. Then push the bottom of the pulp container
towards the base unit. When correctly seated, there should be a space of no more than 1 mm
between the pulp container A6 and the base unit.
5. Cover everything with the lid A3 and push it down into the correct position.
6. Use one hand to push the lid A3 downwards and at the same time tilt the locking arm A8 on
to it so that the lid is secured in the correct position. An audible click will be heard. The juicer is
equipped with a safety mechanism that prevents it from being started unless the lid is correctly
seated and secured in place with the locking arm.
7. Place the juice jug A0 underneath the spout A7.
8. Insert the pusher A1 into the feed tube A2 hole. Notice, that to make movement easier, the
pusher A1 has grooves that slide over the tabs in the top part of the feed tube A2.
9. The juicer is now assembled and ready for use.
B
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SJE 1056 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SJE 1056 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info