684629
8
Zoom out
Zoom in
Previous page
1/10
Next page
EN-8
EN
Egg Cooker
SEG 710BP
2015 01/2015
7. Connect the power cord to an el. power socket. Turn the appliance on by setting the I/0 switch
A0 to position I (On). An indicator light will turn on, indicating that the appliance is running. The
heating plate A3 will start heating the water. The following approximate egg cooking time is
required:
Consistency Approximate cooking time
Soft-boiled eggs 5 min
Medium-boiled eggs 10 min
Hard-boiled eggs 15 min
Attention:
The appliance heats up during operation and steam is emitted from the steam outlet A6. Be
especially careful that your skin does not come into contact with the hot surface or the emitted
steam. Do not open the lid A1 or handle the appliance in any way.
Certain parts of the appliance remain hot even some time after it is turned off. Use the handles
to handle the appliance.
Note:
When the appliance is used for the first time there may be light smoke emitted. This is completely
normal and is not a defect and it will disappear in a short time.
8. As soon as the cooking process is complete, an acoustic signal will be made. Set the I/0 switch A0
to position 0 (Off). The acoustic signal will turn off and the I/0 switch indicator light A0 will turn
off. Disconnect the power cord from the el. power socket. Hold the lid A1 by the handle A7, take
it off and place it on a heat resistant surface. Take out the egg tray A2 and place it, together with
the eggs, under cold running water. Then the shells will be easier to remove and you will prevent
overcooking your eggs.
9. Clean out the appliance after each use according to the instructions in chapter Cleaning and
maintenance.
CLEANING AND MAINTENANCE
Before cleaning it, make sure that the appliance is turned off and disconnected from the power
socket. Allow hot parts of the appliance to cool down.
Wash the removable lid A1 and the egg tray A2 in warm water using a neutral kitchen detergent.
Then thoroughly rinse these parts under running water and dry them.
Note:
Do not wash the removable lid A1 and the egg tray A2 in a dishwasher!
Wipe the heating plate A3 using a cloth dampened in a solution of warm water and neutral
kitchen detergent. Use a cloth dampened in warm water to thoroughly wipe the surface on to
which you applied the kitchen detergent and then wipe it dry.
Attention:
Never apply limescale deposit cleaning agents on to a hot heating plate A3!
Use a dry wiping cloth for cleaning the base unit A4. In the event of heavier soiling, dampen the
cloth in a weak solution of neutral kitchen detergent. After applying the kitchen detergent, wipe
the surface of the egg cooker with a lightly damp cloth and then wipe dry.
Never use abrasive cleaning products, petrol, solvents, steel wool, etc. for cleaning.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SEG 710BP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SEG 710BP in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info